When I pulled the intake manifold/head off the WJ I removed the coolant temp sensor and discovered the connector was mashed up by whoever took it off before. The connector hook is still intact so it connects to the sensor and stays put, but I was thinking about finding a new connector and repinning the connector.
https://postimg.cc/SjKCPp5j
There's a sensor upstream of the wiring harness that uses the same connector - but only has one pin:
https://postimg.cc/DmYLkMk6
Anyone know what kind of connector this is and where I might find a replacement? I haven't tried unpinning it yet-I'm guessing the flat slots under each of the pin are for inserting something to release the pin, but any tips on unpinning would be great too.
https://postimg.cc/SjKCPp5j
There's a sensor upstream of the wiring harness that uses the same connector - but only has one pin:
https://postimg.cc/DmYLkMk6
Anyone know what kind of connector this is and where I might find a replacement? I haven't tried unpinning it yet-I'm guessing the flat slots under each of the pin are for inserting something to release the pin, but any tips on unpinning would be great too.
