I need a 27 spline front driver side inner axle shaft. "chromoly" for a stock non varilok diff. about 18.25" from end of spline to center of ujoint. I snapped splines off my old one so its hard to get exact measurement. may consider a whole set too.
wanted.. front inner axle shaft
Crzhelm
1 - 6 of 6 Posts
I need a 27 spline front driver side inner axle shaft. "chromoly" for a stock non varilok diff. about 18.25" from end of spline to center of ujoint. I snapped splines off my old one so its hard to get exact measurement. may consider a whole set too.
Good luck sir. Those are no longer made or found. Only option would to contact IRO since they are the only ones who make ujoint shafts but you'll pay. Chromo shafts will only put the weak point at the ring gear which is mighty expensive compared to just a shaft.
Like MuddyWJ said, contact IRO as they are the only ones, that I am aware of(and I have been searching) that make a chromo u-joint type axle shaft for the WJ. They MAY sell you only the inner shaft that you need and it MAY work with your outer stub shaft you already have.
Your other choice is to go to RCV's.
Unless somebody knows of another option thats readily available, those two seem to be it.
Your other choice is to go to RCV's.
Unless somebody knows of another option thats readily available, those two seem to be it.
Joined
·
3,055 Posts
You can have a custom chromoly shaft made. I had Dutchmans custom make me a set. East Coast Gear Supply said they could do it too. They'll take a D44 chromoly shaft, cut it down to length, shave it to the proper D30 seal width, and cut new splines in the end.
1 - 6 of 6 Posts
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
