[Jeepnbo]

Went and got my passenger floor cut/welded in by a friend. Took 6 hours and i found out somebody had patched the floor with tin :thumbdown:

 

[Jeepnbo]

Got most of the rot cut out, a layer of rust stop primer over top, and is waiting for a welder. Unfortunately the buddy with one cant find his (they're in between houses) so I need to either find another or buy one... Where you guys welding the rear? To the second seat crossmember?

View attachment 522285

Also started to replace the rear liftgate speakers. Stopped when I broke the THIRD clip tower - any suggestions to get them out?

This Jeep so far has been both fun and EXTREMELY frustrating!!!

After seeing these photos i now have more motivation for fixing my floor!! On a side note, if you order the pans from rockauto be worn there not 100% "drop in ready". Also might wanna check your cargo area too, mines rotted out there too.

 

[Jeepnbo]

Thanks for all the input on tires guys! I have arranged to test out my buddies 33x12.5's to see firsthand what it's going to be about.

I have a line on a set of Liberty 16" alloys which would allow me to run a metric size for the diameter I want, without a ridiculous width to run in snow.
Edit: Jeep is freshly aligned with tcase drop in. All but minimal vibes are gone, and it drives great! Even tested out the highway with no problems. I think the vibes are coming from the front pinion angle, still a bit low. Easy enough fix.

Looks good! 4.5 right? Also do you have a LP dana 30? Time to swap in HP D30

 

[Jeepnbo]

After a few months Jeepless, bought another '99.

Jeep didnt equip this one with the standard issue rust package yet.

What happend to your green one? Noticed you havnt been around as much..