[NIN20]

:thumbdown: , found out i need to replace my throttle response sensor, and crank speed sensor. I'm also in need of a new U-joint in the front and a belt. Other than that I just sat there and looked at it thinking of what I wanna do next

 

[NIN20]

Washed and waxed, Shines beautifuly, now its time to put the mud back on her

 

[NIN20]

flushed the blinker fluid, she was due, lol :cheers:

 

[NIN20]

Got a new license, registered the jeep for the first time in CO, and mounted the new plates. Next up

-new lift
-wheels
-tires

 

[NIN20]

Installed brand new yellow top Optima, that cured the problem!

 

[NIN20]

Dug into the over heating problem I was having. Looks like a new radiator is on the way:brickwall

 

[NIN20]

replaced my radiator:brickwall

 

[NIN20]

I ordered my new engine today. Ill be looking for it early next week

 

[NIN20]

Removed the side moldings andflares, cleaned up the lowers on my doors and herculined them. Came out great

 

[NIN20]

picked up my new tires and wheels. Five 33x12.5r15 BFG M/T KM2's mounted on soft eights. Can't wait to get em on the jeep

 

[NIN20]

Ordered my RE 5.5 LA lift

so stoked

 

[NIN20]

Finally drove it for the first time since July.

<very happy

 

[NIN20]

Fished my new RE 5.5" LA kit by putting in some bar pin eliminators and getting an alignment

 

[NIN20]

new rotors and pads up front

 

[NIN20]

New steering box and brace. so much better now

 

[NIN20]

went out wheelin for a little bit. It had been a while

 

[NIN20]

Drove myself down o sears and bought a new set of tools

 

[NIN20]

Installed my new rear driveshaft from Rocky Mountain Driveline. Super beefy, My old Tom woods didn't even compare