Jeep Enthusiast Forums banner
Cancel

Tools for differential rebuild

19497 Views 12 Replies 10 Participants Last post by  jumbojeepman, 
B
I want to start buying the tools I will need for rebuilding/ re-gearing my differentials, I have a FMS that tell me all the special tools that I will need and I know that I can buy them from millerspecialstools.com. The only problem is that they are so expensive. I haven't asked matco or snap-on dealers in my area. Does any body know where I can buy these tools for a bit cheaper.

Thanks.
Reply
Save
Like
1 - 1 of 13 Posts
XJ99
Also helps if you have a press.

Torin Hydraulic Shop Press - 12-Ton, Model# T51201 | Hydraulic Presses | Northern Tool + Equipment

And a 1/2" impact gun.

DW292 1/2" (13mm) Impact Wrench with Detent Pin Anvil | DEWALT Tools

If you plan on upgrading to a 8.25, you'll need to
buy or make a shim adjustment tool.


I also have several sets of set up bearings.

0.02
See less See more
Reply
Save
Like
1 - 1 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Jeep Enthusiast Forums
A forum community dedicated to all jeep owners and enthusiasts. Come join the discussion about performance, engine swaps, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
TJ Wrangler Technical Forum General Discussion YJ Wrangler Technical Forum XJ Cherokee Technical Forum Jeep CJ Forum
Top