Jeep Enthusiast Forums banner
Cancel

Tapered insert for stock TRE

1130 Views 11 Replies 6 Participants Last post by  wildman4x4nut, 
M
Hi all,

I’m working on an 05 LJ, formerly my fathers and now my mothers. It has a small lift along with a Currie trackbar and steering. My mother has asked if I can lower it back to stock height for her. I know none of this stuff clears at stock height so i am going to be removing it. My only issue is the trackbar bolt has been drilled out for the larger bolt used in the Currie kit.

I was wondering if anyone had a source for a tapered insert that would allow me to go back to the stock TRE. Also open to any solution in which I can clear at stock height.

Thanks.
Reply
Save
Like
1 - 2 of 12 Posts
U
I’m not sure of an insert but I had to weld a piece of steel on the track bar axle mount and drill a new hole when the hole wallowed out.
Reply
Save
Like
U
biffgnar said:
I'm confused which end of the trackbar we are talking about. I thought frame side, but seems like some people talking about axle side.
Click to expand...
I was thinking axle side.
Reply
Save
Like
1 - 2 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Jeep Enthusiast Forums
A forum community dedicated to all jeep owners and enthusiasts. Come join the discussion about performance, engine swaps, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
TJ Wrangler Technical Forum General Discussion YJ Wrangler Technical Forum XJ Cherokee Technical Forum Jeep CJ Forum
Top