Jeep Enthusiast Forums banner

Tapered insert for stock TRE

1138 Views 11 Replies 6 Participants Last post by  wildman4x4nut
Hi all,

I’m working on an 05 LJ, formerly my fathers and now my mothers. It has a small lift along with a Currie trackbar and steering. My mother has asked if I can lower it back to stock height for her. I know none of this stuff clears at stock height so i am going to be removing it. My only issue is the trackbar bolt has been drilled out for the larger bolt used in the Currie kit.

I was wondering if anyone had a source for a tapered insert that would allow me to go back to the stock TRE. Also open to any solution in which I can clear at stock height.

1 - 1 of 12 Posts
I'm confused which end of the trackbar we are talking about. I thought frame side, but seems like some people talking about axle side.
1 - 1 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.