Jeep Enthusiast Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
Located in western Maine. 1985 T176 four speed and Dana 300 transfer case, bell housing, skid plate, shifters, boot, clutch and pressure plate too. Approx 130k miles. This is a complete setup. May possibly need a front input shaft bearing? (a little noisy?) Working great when removed, I swapped in a T18. Thinking $1,500 for everything. Will deliver to most of New England.
.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top