Jeep Enthusiast Forums banner
1 - 1 of 1 Posts

·
Super Moderator
Joined
·
23,971 Posts
When I put on my new frame I had my whole harness attached to the tub. Not a single wire on the frame at all. Makes it real easy as almost none of the wiring is exposed to elements. But since I drive in winter salt all the time, that was the whole idea. If I need to lift the tub I just have to disconnect a couple of wires on the tank of tranny and lift the tub off again.

Is that how the fuel pickup sits in the bigger tank or can you change the direction of the outlet connections? Thinking about going to a bigger tank but hate to re-rout he whole fuel system.

Awesome job though. I wish I had welded my roll bar tie ins before I finishe painting my frame. I hate to gring off all that epoxy primer and frame paint.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top