Jeep Enthusiast Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
My latest project/build. Started with my running/driving 1994 Jeep Wrangler, 4.0 6-cylinder, manual 5-speed. 7 weeks later it now has a 2005 5.7 Hemi and 5-speed automatic (545RFE) and the stock 231J. I had previously installed a SYE, CV joint shaft, and Explorer 8.8. Though there are many Hemi Jeep kits there are no kits built or sold to install one into a YJ. I have only found 2 YJ's with hemis on the internet! I built my own custom motor mounts, transmission mount, air intake, exhaust, t-case shifter mounts, etc. etc. etc.... I was able to position the motor so that I could use an engine driven fan. I used a Lokar shifter and both shifters come up in the stock position and are actually covered by the factory boot. I even have all of the factory gauges working including the tachometer. Though it ran fine with the stock fuel pump it was bleeding back and I had to cycle the key 3 times before it would start. I installed a Walbro 255lph pump and now it fires immediately when you turn the key.



[/URL][/IMG]

[/URL][/IMG]

[/URL][/IMG]

[/URL][/IMG]

[/URL][/IMG]

[/URL][/IMG]

[/URL][/IMG]
hello my friend. i have a wrangler yj 1994 4.0. i want to swap a hemi in it and i also want the stock gauges to work properly. what harness did you use for the istallation ? thanks in advance
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top