Jeep Enthusiast Forums banner

Kenbo's AtoZ cage install.

4826 Views 14 Replies 8 Participants Last post by  jatepper
Here is the formal thread for my cage install for those who have not seen it.

I ordered the cage kit from Zach at AtoZ Fabrication and it sat in my garage for over a month prior to me getting time to fit it (work and school are killers).

Here is the kit, fresh out of the box.


Fitting the upper bars to go to the windshield.


The stock windshield mount gets fitted to the other end of this piece. The OD of the mount fits the ID of the DOM tubing in the kit.



Next comes the center hoop


Next comes the upper windshield bar and intermediates from that to the center hoop.



Once that's all welded, the A-pillars are next. THIS TAKES TIME!

cut the dash, trim some metal stuff the tubing in (multiple times) mark and trim a little at a time. This goes to the base plate in the floor bottom base plate is the AtoZ rocker guard (if you have them) if not, standard steel plate.



Here is Andrew doing some fitment.


Next is the bottom windshield intermediate.


The handles are cake, haha.


The rear half of the cage is simple as it comes...... Pretty cut and dry, ask questions if you have any.


That is pretty much it...... I was too busy to take a ton of pictures but I can answer any install questions or snap certain pictures to help explain anything.


1 - 1 of 1 Posts

· Registered
Joined
·
7,324 Posts
What type of tube?
Was this a custom order kit?
I see on their website the rear kit has the hoop which the two upper bars attach to but yours attaches directly to the stock cage.
Was the fitment good or did you have to cut to fit?
Cage looks good.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top