Jeep Enthusiast Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello everyone,

I own a 2003 Jeep Wrangler. I am dealing with an issue that happened today after installing my KC 4’ rally lights. I picked up a wire harness from harbor freight and me and my buddy spliced and put the wires together to my original wire harness to make the installation faster and easier. Lights work and everything. After I installed these lights, I was driving my jeep to the gym and I noticed my turn signal and hazards were not working. When I came to a complete stop, they worked again. When I even had the lights on, they worked at a complete stop. When I would drive it would glitch for one second and then not work at all. I’m wondering if I burned a fuse and the other part I’m thinking is if the signal on the lights is too strong. Please leave any suggestions or ideas if you guys have any! I also had LED spot lights on previously and I’m just lost and confused at this point.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top