Jeep Enthusiast Forums banner
1 - 1 of 4 Posts

· Registered
Joined
·
1,038 Posts
I'm no guru but I'll pitch in.

If you have the gears there with you, you can get the ratio if you just
count the teeth on the ring gear and divide by the number of teeth on the pinion.
An automatic 4.0 would have a 3.55 ratio.

The end cap in the third picture is positioned correctly, the "V" marking on
the cap matches the marking on the housing face. Can't tell from the fourth
picture as markings are not visible enough in the pic.

All in all the gears look to be in good condition. If it wasn't wheeled much,
there doesn't have to be much lash in the gears if gear oil was changed on time.
The few shavings on the plug are no big deal.
 
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top