Jeep Enthusiast Forums banner
1 - 2 of 4 Posts

· Registered
726 Posts
Discussion Starter · #1 ·
Never pulled an engine before and need some guidance. I'm looking at the 1-ton shop crane from HF:

I know it can handle the weight, but the specs say the boom only has a range of 69-5/8 in. to 82 in. Is 12 inches of travel enough to get the engine out? Also, how do I get the engine on the ground (pallet) once I have it out?

Looking at the specs of the 2-ton crane, it's only got 4 inches more travel.

I know people do this stuff all the time, but I can't seem to visualize the process. I've been searching youtube, but not having much luck.

1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.