Jeep Enthusiast Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
15 Posts
No nut on orher end
Stud has fine thread on the firewall side ( where you can see inside engine compartment) and there is a course thread on the other end which screws into the plastic plenum these two threads are seperated by a hexagon fixed washer which seats against the plastic.
So if nut & stud are turning together it should come out with no problem
Could send a picture if you want ( just give me an e-mail address, as i seem to be unable to attach files over the allowed limit of 109K ( or somthing in that range)
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top