Jeep Enthusiast Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
519 Posts
Discussion Starter · #1 ·
ZJ 4.0 97 with Infinity gold sound system. looking to replace radio to a pioneer DEH-x6700bt. a friend wanted to install it. now it turns on. but no sound. havnt checked all illumination functions but seems to work but no sound at all. anyone got a diagram. or write up. or anything thatll help me know what wires go to what. as well as the third harness with a white clip? that one puzzles me deeply
 

·
Hears the voices
Joined
·
16,786 Posts
The third harness is the CCD bus for the steering wheel controls and the clock in the VIC.

The amp uses the power antenna wire to sense that the head is on, on most aftermarket heads there are two wires, one is for a power antenna and is only on when in a radio mode. The other is usually labeled remote and is for triggering power on external amps. You need to make sure that the head side harness remote wire (usually blue and white) is connected to the jeep side harness power antenna wire (usually blue).
 

·
Registered
Joined
·
519 Posts
Discussion Starter · #3 ·
okay. i read somthing that the green wire with red tracer is the power feed for the factory amp. ill dig it back out and take a look. i disconnected it and put the stock radio back on.
 

·
Registered
Joined
·
320 Posts
Here are the pinouts

Radio connectors


Amp




Sent from my SM-G900V using Tapatalk
 

·
Registered
Joined
·
320 Posts
Here are the wiring diagrams:










Sent from my SM-G900V using Tapatalk
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top