Jeep Enthusiast Forums banner
1 - 1 of 1 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
Jeep has had a bit of death wobble. Changed all four ball joints, and this is what the new ball joints look like. Drivers side has about 1/4" more gap between the knuckle and the inner C than does the passenger side.

Is this a bent C, and if so, can I fix it?

Note, I have over 200,000 miles on this vehicle.

2007 Jeep Wrangler Rubicon


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.