Jeep Enthusiast Forums banner
Cancel

BEAST Notcher

2805 Views 4 Replies 1 Participant Last post by  JDSquaredInc, 
J
Beast Notcher


​

The Beast is the ultimate in hole saw tube notching. Able to easily handle straight notches, offset notches, angled notches, and notches in bends.

The weight of the BEAST notcher is 50 lbs. This helps with the chatter and saves longer on your hole saws.

List Price - $499

Features:
* Capacity of 3/4" to 3" OD
* Angles up to 50°
* Can offset notch up to half the tube diameter.
* 1" Ground & Polished Stainless Steel shaft
* Double sealed needle bearings.
* Clamps allow you to notch on a bend.
* Requires an ordinary 1/2" hand drill
Save Share
Reply Quote
1 - 5 of 5 Posts
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Jeep Enthusiast Forums
A forum community dedicated to all jeep owners and enthusiasts. Come join the discussion about performance, engine swaps, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
TJ Wrangler Technical Forum General Discussion YJ Wrangler Technical Forum XJ Cherokee Technical Forum Jeep CJ Forum
Top