Jeep Enthusiast Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Just changed my transmission in my 96 Jeep Grand Cherokee limited ... An when I went to put the overdrive extension housing on it goes almost all the way up to the transmission leaving a half inch gap... An I can't figure out why it want slide the rest of the way up... Do I need a special tool ???? Or am I not matching the splines up right ? Please advice someone I'm desperately in need....
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top