Jeep Enthusiast Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
111 Posts
Discussion Starter · #1 ·
Hello all. So, about 4 years ago, I put a 3 inch IRO lift WITH Bilsteins on my WJ, but it wasn’t driven a ton. Tie rod, tie rob ends, upper and lower ball joints are all replaced within the last 2 years(again, wasn’t driven a ton cuz I either worked at home at the time, or it was only a 10 minute drive to/from my work, now I drive a little farther, everyday).

Anyway, It’s now developed the dreaded Death Wobble. Going over any significant bumps causes it. Any thoughts as to what might be the cause?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top