Jeep Enthusiast Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
So I have this what I call a death rattle in the front end of my 2007 Grand Cherokee 4 wheel drive I have replaced upper lower control arms tourettes lower ball joints end link bushings and sway bar bushings. The rattle still exist. I have been purchased new upper strut mount bearing plates a rack and pinion bushings enter outer tie rods which is not been installed yet. Labor is a fortune and by the way the coils and struts are Detroit Axle only two years old 8,000 miles on them no off-roading. What am I missing to find this rattle from hell? If I install the new upper strut mount bushing plates and tie rods inner outer will it stop the problem or is it a CV axle joint issue? Any comments are greatly appreciated thank you I'm at my Wit's End and I've dumped a ton of money into this.
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #2 ·
Seriously if someone even gave me a call and chat with me briefly about what situation maybe would be greatly appreciated at area code 805 721-2941 it does have a 3 inch leveling kit in the front one and a half in the rear.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top