Jeep Enthusiast Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-9 of 10 Results
  1. JK Wrangler Technical Forum
    Hi All, I recently installed a Smittybilt XRC Gen 2 rear bumper and tire carrier combo on my 2013 Jeep JK. I'm having a problem with the bottom pin bolt rattling out over a short period of time while driving. I have gone through two bolts and only had this installed for 3 weeks. For those...
  2. General Jeep & Off-Road Equipment
    Just got done installing my smittybilt XRC 9,500 winch. Checked and double checked that the wiring was lined up with how it was labelled and then plugged in the remote to try it out. The remote says Out and In, but when I switch it to OUT, it spools in and when I hit IN, it lets more line out...
  3. YJ Wrangler Technical Forum
    I bought the xrc seats and the site said they would fit fine without replacement seat brackets/risers. my legs rub the steering wheel and my head hits the roll bar. it's borderline unsafe. Does anyone know of replacement brackets homemade or not.
  4. Jeep Picture Requests
    Does anyone happen to run the Smittybilt XRC body cladding that goes along the rockers with stock fenders for a JK? Preferably on the unlimited but 2dr will work too. Im curious to see what it looks like.
  5. YJ Wrangler Technical Forum
    I bought a used set of XRC flat fenders. Does anyone have the cut template they do not need anymore? They are the ones with the 3" extensions.
  6. JK Wrangler Technical Forum
    4wheel parts is offering if you buy the XRC front and rear tire carrier bumper they will give you free the XRC fender flares (normally $400). I like the bumpers and seem to be a good cost point, just not sure about them. I wish the front had provisions for the factory foglights. I am also kind...
  7. YJ Wrangler Technical Forum
    I've been looking everywhere for a photo of the XRC rear tube fenders without the rear corner guard. I'd really appreciate some help! :confused: Preferably a photo of a YJ, but a TJ or CJ will do. I own a 94' YJ if that helps at all.
  8. Winch and Plate Holder

    Installed the Smittybilt XRC-8 (generation 2) winch and the EZ Flip license plate holder that flips up and and down when needed
1-9 of 10 Results
Top