Search Results for ‘transmission bolts’

Back to the forum I come after 45 minutes of googling... I'm trying to figure out the bolt size for the rod that connects to the bell housing. The only thing I can find online is this picture off the engine side - the rod I'm looking for connects to this and goes to the bell housing on the...

Hey everyone, I recently swaped my transmission and realized I was missing two bolts and can't find these bolts anywhere, they don't hinder the performance of the car but there's a rattle when it's not on, I have a 1994 jeep wrangler yj 2.5L with an ax5 transmission. If anyone knows the thread...

So here's the thing. My first problem is my jeep is an auto. Now that we have that out of the way, I have lost a bolt that goes to the linkage rod for my steering column shifter. Any idea where I can find this bolt without purchasing an entire linkage kit? Help!!

I am new to working on vehicles wanted to change my 2005 wrangler X TJs manual transmission fluid. Well.. i accidentally unscrewed the wrong bolt and i can't get it back it. the bold was on the drivers side about mid way up the transmission. Its 13mm and is about as long as finger (rough...

Like the title says, the bolts on the skid plate for my trans pan wont stay in. The two smaller ones that attach to the transfer case skid stay in but the larger bolts that go into the frame will not. With the drivers side bolt I can screw it in all the up until the last 1/8th inch or so of the...

Whats the trick to getting the transmission pan off? I've removed the bolts, and separated it from the RTV sealant no problem, but cant seem to work it out between the crossmember and exhaust. now it's just dangling there, and no amount of twisting and turning seems to be able to set it free...

Now I know a lot of people have had issues with getting the 2 external Torx bolts on top of the engine, and I have already taken the engine out and am in the process of putting another engine in. I seemed to have lost the bolts that are around the rest of the bell housing that connects the bell...

Hi all I recently purchased a 81' cj5. T176 tranny with Dana 300.. I already replaced all the shift forks, shift lever, 3rd and 4th lug, the balls and springs seemed to be fine, all the gears appear to be in pretty good shape also. however i keep getting kicked out of 3rd gear! After some...

I tried removing my skid plate to sand and paint it since its all rusty. I read about how the transmission is bolted to it and all that. So I supported the transmission with a jack and tried to remove the bolts but they wont move. Any ideas?

New to the forum, and this is my first wrangler. My tj started making a thumping noise at low speeds so i was checking the transfer case shifter assembly to see if it could be the culprit and noticed these empty bolt holes. Is there something misssing here? If so what is it? 2004 Jeep wrangler...

Guys I heard the stories about the top two stud looking bolts that have to come out of the transmission to unhook from the engine. It took me less then 20 mins and this my 1st time ever removing any engine at all. Here is what I used my impact wrench a 3inch extention a 1/2 to 3/8 redue socket...

so i have a 1980 cj7 4.2L |6 and the dreaded SR4 went out in it. i am trying to get a used transmission from a self service junkyard but i need to know what transmissions have similar bolt patterns to the SR4. also i wan to know if it would be easier to keep my bell housing and get a new...

what kind of socket do i need to remove the two top bolts in 01 tj 5speed are they star torques or what am i dealing with??????????????help