Search Results for ‘trans’

Have a 05 liberty 3.7 42rle 4wd. Trans won't go in gear. Access to a 08 Durango with 5.7 hemi. Trans is a 45rfe or the 545rfe. Will it work? Thanks in advance

Hey all, Yesterday and today I've been having issues with my wrangler shifting. I can't downshift without coming to a near complete stop. I can start in 1st and climb through all the gears, 1st to 2nd to 3rd to 4th to 5th. However, once I leave 1st I can't get back into it without stopping, and...

Hey guys, So I "totaled" my 96 zj a week go. It needs body and front end work that I'll probably work slowly on over the next few months. Anyways, I bought a 95 zj (4.0 42re) with about 150k for $500. Pretty good shape except for the trans. I limped it home, unable to really go over 40 mph...

I have two, 1994 jeep wranglers. My blue wrangler was crashed, lukily just the tub was damaged and not the frame. It has a 4.0 with an automatic trans. I bought a white jeep that has a 2.5 with a manual transmission. The Engine burns coolant. I want to take the body from the white jeep and...

Okay, I have a 04 TJ auto, I have recently switch it to a manual. After that it would start and drive with a check trans code no problem. Then my battery went dead on me. I replaced my battery and now no start. So I thought well the PCM was looking for the auto trans, found one put it on trans...

My trans pooched so I bought a used one that is supposed to be a 46rh and as far as I can tell I had a 46rh on my 5.2 v8 but when I got my trans dripped I discovered the bell housings dont match. The one I pulled from my zj had the starter in the lower left side and the "new" one has it on the...

I probably need to do some more research on other sites but I always end up here for the good answers. So the stock YJ is not wanting to downshift nicely nor shift into 5th. The rest of the gears on upshift seem fine. Occasionally it is dificult to get into first after coming to a no clutch...

I have an 82 CJ5, with a 151/T5/300 driveline. The belhousing has a chunk missing out of the bottom, about 2"x1". What bellhousing can I use to replace this with? Could I use one out of a camaro, since it would be a T5 with the chevy bolt pattern for the Iron Duke? This is bothering me!

How are codes retrieved on pre-1996 vehicles? Our 1995 does not have a DCM2 plug-in? It has an ECM and a TCM ( trans) and we need codes to determine why the upshift is delayed.... might be speed sensors and might be something from the engine code. Anyone?

I have a 1996 XJ Limited 5.2L. I am poor. I can't afford to take my vehicle to a shop. Period. I am having an issue to where when the Jeep starts up cold... it runs fine/shifts fine. However, firstly I guess I will say that (all motor mounts have been replaced, yet when I "goose the...

Anyone know what size the bolts are that attach the auto trans skid plate to the frame on an 05lj? 2 are threaded into frame and 2 are threaded into the main skid plate underneath. Have tried various sizes but none seem to fit.

Okay new to jeep, and this forum. My question is I have an Ax-5 trans in my 1995 jeep yj 2.5L and I need a new trans "I think". I've looked all around my area for a Ax-5 the closes one is 6 hours away, since I work 7 days a week 13hr days that's kinda a long drive. Im wanting to know if there...

96 xj 4.0 4x4. auto trans. recently it would rev up while driving then kick back into gear. only did it once or twice in like say a 60 mile drive. the check engine light came on threw a o2 sensor code after the converter.. well tonight while driving down the highway it kicked out of...

I have a 96 cherokee 4.0 4x4, np231 transfer case, AW4 transmission.. When i drive it for about 20 minutes the trans will act like its in neutral then jump back into gear.. without moving the pedel it will rev up then kick back into gear. figured maybe my trans was going out, today it...

ive got a 95 yj i just got with a 2.5 and im not sure what trans its a 5-speed a tx5 maybe? im not sure but it grinds in to 3rd and 4th bad and sometimes 1st and 2nd on a hill with the cluch pedal out and in gear it still can roll backwards is this a clutch issue? and it bucks from time to time...

im trying to put the trans back together and when im assembling the main shaft i get the 1/2 gear sychro on and then the snap ring, then when i put on second gear and try to put the tabbed thrush washer and snap ring there is not enough room for the snap ring to go in the grove. second gear...

long story short but was pulled over, motor running, parking break on, and in neutral. was distracted with person pulled over also and put into 1st gear engaged clutch quickly remembered parking break was on as I was in a rush to release the break at the same time looking for p.b. handle didnt...

I have a 95 YJ thats manual trans was falling apart, and I didnt have the money to fix, so I pulled an automatic out of the scrap yard to install. The manual held togather for a year but finaley quite. after trying to install the auto a few things went wrong: it was an 1" shorter in overall...

1998 TJ 4cyl A904 Thanks in advance! Fuel Issue(s): 1. Since purchased jeep has never started on the first crank. Always starts up on the 2nd. After reading around I believe this is a leaky check valve. Any issues with running this way? 2. Jeep idles rough (when cold) and boggs pretty bad...

I have a 2001 tj with stock auto trans and noticed some slip 1st into 2nd (very slight). I flushed the trans, replaced the fluid, droped the pan and replaced the filter. No slip anymore and it really changes gears now smoothly with no buck at all. Have i fixed the problem or just covered it op...