Search Results for ‘track bar’

Hey guys, I knew I needed to replace my track bar for a little bit of time now, so I figured I'd reach out here and get some input before I pull the trigger. I will be getting an adjustable track bar with a frame mount, but just not sure from whom. The only threads I could find were back from...

Hey guys, I'm in need of some advice here. I've had enough of the shaking and rattling and popping on these Michigan roads that I have to get this fixed. I need to know if I should get a new joint and replace the entire thing, or if I can just tighten it and it'll be all good. I've looked at...

After searching, I could not find an appropriate thread, so I figured I ask you all for a little advice. 2004 TJ 4.0 Rubicon 42RLE When I was finishing up putting an ome kit on the TJ, as I was wrapping up the rear suspension, I went to switch out the stock rear trackbar to put in an...

Hello all, I have been considering getting a lift for my TJ. I am on a tight budget (college student) but I have been wheeling my jeep more often and I could use a little extra height. I am considering a Budget boost. Before I got my jeep I lifted a truck and it caused significant issues. What...

hey guys ill make it short. I installed a lift, in putting the new track bar in I had to drill the upper mount hole out from a tapered 1/2 to a straight 5/8 now (sadly) I need to take the lift out. the only issue is that this new track bar, though adjustable to fit length wise, hits my front...

Product Information Price $250 Manufacturer Teraflex The Teraflex monster track bar looks much like the stock track bar, but is much larger diameter and "stronger". (still testing the strength) As with any track bar, pretty easy and straight forward install. As...

I just ordered a new one because the one on my front track bar looks deteriorated. Has anyone had issue with these getting worn out and causing death wobble? I have checked and replaced all worn parts in the front end, tie rods, ball joints, unit bearings, and control arms. I am still getting...

I have bump steer. It's pretty bad, and makes driving at speed pretty sketchy. I recently installed a Teraflex 4" L.A. kit, bump steer started after the installation. I think I could probably solve this a few different ways, but looking on advice on the best way to do it. As always, money is a...

Previous owner installed rough country 3.25" lift and front track bar. I replaced it with a 3" spring/shock lift from BDS. The front trackbar however hits the diff cover. Thinking about replacing it with a stock bar. Has second hole drilled on axle side mount and a rough country bracket below...

Previous owner installed a RC 3.25" lift and RC track bar in the front. He had it installed by a shop and looks like they drilled another hole to the lower right of the original hole. I am planning on putting a stock bar back on. Should I worry too much about the extra hole causing stress on...

Hey everyone. Is there a way to rebuild the upper frame end of a front track bar? Where do you get the parts? I suspect a pickle fork will trash it and it's boot. I can't get a tierod remover in there and turn its pin. It has to come off to press in a bushing on the axle end. Thanks all.

First time, long time, great to be here. Got a question for y'all: I have a 09 Wrangler X full stock front end. It has a wobble/shimmy/shake, just short of the DW since it goes away at around 20mph. took it to dealer, they say i need to replace Ball joints, tie rods (RT in 52060049AE, RT out...

Hi im new to this forum. I have a 1995 jeep grand Cherokee Orvis edition. Just bought it a few months back for $500. Has 160,000 miles and a 5.2 v8. Already has a 3 inch coil lift. I'm putting another 3 inch bb lift on soon. I plan on getting front upper adjustable arms and a front adjustable...

This is my first jeep, I don't know too much about them yet. I own a 1995 wrangler. My mechanic told me I need a new track bar, sway bar, and shocks. Also, in the near future, I am hoping to get a new frame (my mechanic emphasized that he does not know how it has not fallen apart in two...

I have a 2006 Wrangler that I love, but am so freaked out by this death wobble that I'm considering never driving it again. Recently, the track bar snapped out the blue and I had it replaced by a local mechanic shop. About a month or so after getting it back on the road, I started experiencing...

Im in the process of swapping out my rear axle (44a) for an identical one and I'm replacing the track bar while i'm at it and i was curious: at roughly 4.5" of lift should i keep my rear track bar relocation bracket or use the factory mount?

Hey guys, so I over the past 6 months or so, I have had a definite pull/drift to the left on my 96 ZJ. More recently, the front end feels very loose when going over bumps, potholes, etc; and I even experienced a shimmy or two and one definite 'Death Wobble'. From what I can tell, the control...

Hello and thanks for all the help! I've just finished getting a broken 98 niner back on the road. Purchased it for $600 because the transmission and suspension appeared to be broken. Thanks to all of the articles on this forum, I've been able to make it road ready again. The transmission would...