Search Results for ‘sway bar links’

I recently bought a 2011 jk sahara with 33's and some kind of lift I assume. PO undercoated the entire jeep including the suspension so I am at a loss for finding out how big of a lift is on it. I think the sway bar end links are still stock because the bar is sitting at a downward angle and I...

Title says it all. My mechanic told me that the clunk from the rear end was coming from my sway bar links. So I'm going to replace them. Question is: should I also replace the sway bar bushings? Wanted to get your opinions. Thanks in advance and forgive the novice question. But hey, I'm a...

I broke a factory front sway bar link this weekend. I think I want to go with JKS quick disconnects for the replacements. I have a 2" DBS lift with 3/4" leveling pucks up front. Do I consider my front lift to be 2.75" and go with model number JKS2001 (2.5"-4" lift) or do I go with module...

Need some assistance..... Sway bar link keeps slipping off quick release stud after twisting support arm (technical name???) attached to stud. I fixed it once when the stud twisted downward by using the weight of the ZJ and a well placed jack stand to bend it back into place. I took it out for a...

After taking my TJ to the dunes this weekend, someone noticed that my driver's side sway bar (stock sway bar with the ball joint at the top) was no longer connected to the axle at the bottom. Apparently the bolt/pin either fell out or broke. The other side is still connected. This seems...

I have an 07 JK 2 door Rubicon. I'm looking for a cheap lift kit to just get a couple inches. nothing major. http://www.rustysoffroad.com/jeep-suspension/jeep-suspension-lift-kits/jk-wrangler-rubicon-07-jeep-suspension-lift-kits/rustys-jk-wrangler-2-budget-kit-includes-shocks.html I like this...

Hi, recently picked up another Jeep (sold my last one and regret it) anyways. Installed a 3" Zone offroad kit. Came with the shocks and coils and leafs. Ever since I have lifted my Jeep it seems any bump I hit doing over 70 km/h that's angled to the right sends my Jeep into a mad Death Wobble...

I expect most of you to know what this is, but my question is HOW it got this way without any real wheeling (unless you count going over speed-bumps at an angle....) Actually happened a while back. I finally got a sturdy extension setup - looked at least as strong as stock- and it bends like a...

I just installed the Zone Offroad 2" spacer lift for my 03 TJ and wanted to give everyone a good heads up prior to doing it. Obviously before doing any work PB Blaster is a must, but even after a week of being drenched in the stuff there were a couple problems. I also recommend before even...

I put these links on December 8. Today I see the damn thing is broken. I haven't done any wheeling or anything. The worst thing I've done is jack it up and down working on it, so I guess now I have to take both of them off take them back to advanced auto and get them replaced, but I don't want...

When offroading today i broke my sway bar Link on the drivers side. I purchased a new set from Quadratec.com and until then i want to remove the broken link. What is the easiest way to get the top link out of the sway bar? Any help will be greatly apprecieated.

what are anybodys recomendations on installing quick disconnects with only 3 inches of suspension lift? any recomendations on what brand to use? do they have sturdy adjustble quick disconnects so i dont need to replace them when i eventually add more lift? thanks guys any input is helpful! :help:

I have added 6.5" shackles to the front and rear springs. On the front, do I need to change the connecting link to the stabilizer/sway bar or can I use the original length ?

So my disconnects are noisy.. i tried white grease...it helped..but they rattle to much Are the JKS ones more quiet? they have an actual grease fitting..which mine does not.... these are about 8 months old...and i can't stand them..wanna swap them out asap...

So we're trying to install the new sway bars, but we realized that there are 2 different size sleeves, I what I don't know is if it is the larger sleeves that go into the front sway bar? RC directions are not the best, if you've never done this before :mad: . Any and ALL help is appreciated...

Yup...I'm a newB...... Finally getting my lift in this Sunday - cant wait! pics to follow... My question is - If I have an RC BB with shock brackets (not bigger shocks) - would sway bar disconnects be pointless?? Thanks! Cant wait to post my pics Tuesday...finally!!

Not sure which disco's to go with. Had the jks before and one of them broke on me. Thinking about the rubicon express but not sure. What is everyone else using? pro's/con's etc...?