Jeep Enthusiast Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 340 Results
  1. YJ Wrangler Technical Forum
    Hello guys, i’m in the middle of an aw4 swap to my 4.0 HO YJ, i got a wintershifter and the control kit from Radesign. How can i locate the solenoid wires? Is there any other surprises should i expect (flexplate, cranshaft sensor…)? thank you!
  2. Engines & Drivetrain
    I bought a 2002 4.7 out of a liberty and am trying to put it into my 2005 GC limited everything went I. Fine the old motor had a egr as the 02 does not everything else plugged I. Just fine however now it cranks but won’t start. I’ve replaced the crank and cam sensor and checked all the coils...
  3. ZJ Grand Cherokee Forum
    I am looking more if this can be done. My 4.0 has developed a issue, it feels like low compression in a cylinder. Basically it has a shake at low idle, but it seems to run ok and the vacuum is ok and the mileage is not that bad, so I am going to have to do a compression test and see. It does...
  4. YJ Wrangler Technical Forum
    Hi all, first post here on wrangler forum, but by far not the first visit. My father has a 1989 Jeep YJ which he has supped up with the following upgrades. - Nv4500 4x4 ram - Atlas transfer - Tomwood CV - ARB back diff - Dana 30 with warren disconnect hub front diff - Rear disc brake - old man...
  5. TJ Wrangler Technical Forum
    About 4 months ago I had a stock 3 speed auto in my Tj. Unfortunately, it was starting to go out and none of the transmission shops near me would touch it. Well I always wanted a manual transmission and always wanted to learn how to drive one. I did a bunch of research and after two weeks of...
  6. TJ Wrangler Technical Forum
    I've been lurking long enough to know of the very ubiquitous 8.8 rear axle swap. I haven't seen a great deal of info on what are the common front axle swaps people do barring a jump to one tons. I'd be really interested to see what people have swapped or commonly swap for the front axle...
  7. TJ Wrangler Technical Forum
    Alright, so I got a wild hair and thought that I could swap in an 8.8 for my dana 35 in the rear. I am about halfway through my project and I am having some concerns. 1. When I weld up all the mounts and mock it all up if my measurements are off a little bit whats going to happen? 2. If it is...
  8. Jeep CJ Forum
    For my birthday I acquired a 1979 CJ7 with an AMC304 swapped in, but on the hour and a half drive home it ate some crankshaft bearings. The whole thing needed a bit of work work, so I decided to do a full frame up restoration (not going full original, but as reasonably close as I want) but it...
  9. Engines & Drivetrain
    Looking for any and all advice on an engine replacement. I'm a relative novice when it comes to engine work, so hear me out here. I've got a 2000 TJ Wrangler with the ol' 2.5L 4 cylinder engine. It recently developed a knocking, and as opposed to diagnosing and attempting to fix whatever is...
  10. YJ Wrangler Technical Forum
    Hi everyone! I'm in search of some answers regarding rear axles in the YJ's. I have a 88 YJ Base that I bought a while back. When I bought it the previous owner said that the owner before him replaced the rear axle with a higher ratio gear setup. I'm not sure what it is currently but I know the...
  11. YJ Wrangler Technical Forum
    On 1995 Jeep YJ 2.5L with 3 speed automatic it is originally equipped with ECM part #56028833 for an automatic; these are hard to find, especially in Belize. Chrysler discontinued making them. I sourced a 56028842 for same year from...
  12. TJ Wrangler Technical Forum
    2003, Sport, 4.0, 145k, Caught a rod knock about two weeks ago; parked her immediately. Researched and called around for a few opinions. It was on the lower end, passenger side, no change in power or oil pressure; attempted a repair to drop the oil pan and look inside and got in over my head...
  13. Engines & Drivetrain
    Hello everyone, I am a new member and just joined a few minutes ago, and was hoping I could get a quick response. Sorry if this thread is in the wrong location! I just got my first Jeep, it is a 2000 Grand Cherokee 4.7L v8 4x4, and the engine is blown. long story short my aunt bought it...
  14. Engines & Drivetrain
    I know this has been posted a lot, but couldn't find the information I needed. I am looking to do a HP44 front and a ford 9 inch in the rear. I was wondering if anyone had information on doing this swap from a salvage yard. I am trying to get as close to stock width as possible, also wanting...
  15. Engines & Drivetrain
    I'm looking to swap a 4.0 engine and 4 speed auto trans into my 88 YJ (currently has the 4.2l I6 w/ Howell EFI conversion). I am considering 2 possible donor vehicles, a 1995 XJ or a 2001 XJ. The 2001 can be test-driven, the 1995 can't as it's missing some parts but I can still verify engine...
  16. YJ Wrangler Technical Forum
    I have a 1988 YJ with the 4.2l, 3 spd auto trans and 2.5" Suspension lift, and Howell EFI conversion. Need a new rear end (drums are rotted), transmission is on its way out, and engine is tired and out of spec. There is a guy near me selling a 95 XJ Cherokee that runs and drives but has rotted...
  17. Engines & Drivetrain
    Hey everyone I am new to jeeping and have a red TJ lifted 4" on 32" i6. Love this thing and it's amazing! I want to make it a solid rig for doing some big fun road trips this summer and run 33" tires with rear diff locks. It's currently Dana 30/35 and I understand that that Dana 35 will shatter...
  18. YJ Wrangler Technical Forum
    I recently ate up my AX5 which I've read many places isn't abnormal. I own a 1994 YJ with 4" Suspension lift, 2.5l 4 cyl with stock Dana 30 and 35 axles. I'm looking to pull an AX15 from a junkyard tomorrow, but before I pick one to yank out, I wanted to see if anyone here has any experience...
  19. ZJ Grand Cherokee Forum
    I've been looking online for a good guide on how to take out a 5.2 engine out of your ZJ. I found many for Dodge Rams, but none for these jeeps. So what i will be attempting to do, put a decent, helpful story on how i removed my engine. So long story short i was mudding with some friends and...
  20. TJ Wrangler Technical Forum
    I recently wrecked my tj and insurance found out and totaled it, but they won't pay stating it's my fault. So I decided to rebuild it by swapping the frame and tub to one with a clean title, I've found a 4ç frame and tub for 600 that had a motor fire but still appears to be in good shape mind...
1-20 of 340 Results
Top