Search Results for ‘steering knuckles’

Last time I drove I was going into death wobbles when I hit potholes or uneven road and that was unusual, not good going down the interstate. I jumped under the jeep and started to wiggle things and found when I wiggled the drag link (drag link goes from the pitman arm to the passenger knuckle)...

Jeep has had a bit of death wobble. Changed all four ball joints, and this is what the new ball joints look like. Drivers side has about 1/4" more gap between the knuckle and the inner C than does the passenger side. Is this a bent C, and if so, can I fix it? Note, I have over 200,000 miles...

What is the standard lubrication for closed steering knuckle. Going mostly off of Ludel's discussion in Jeep Bible and restoration manuals, he suggests using lightweight chassis/u-joint grease although he acknowledges some Jeep manuals would use 140wt oil (and the fill plug is much like a gear...

Hey everyone. I'm swapping out my u-joints in the morning. I've never tackled anything like this, but I've heard it's a relatively easy job. However, I have a tendency to **** **** up from time to time, so I just wanted to fish for some helpful tips/comments before I go down there and get mad...

I am currently working on replacing the sway bar end links, TREs, and Upper and lower ball joints on my 92 Jeep cherokee Briarwood. The vehicle is stock as far as the suspension goes. I used a 4X4 ball joint press rented from Advance Auto Parts. (Vastly superior to the one @ Autozone). I...

what is a 6 or 2 bolt steering knuckle and what does it have to do with which brake pads and rotor i get . please help

I've completely rebuilt the front end on my 83 CJ-7 (just because it needed it, not to attempt to fix this problem) - had it to the alignment shop - everything is good. I get a slight wobble above 50 MPH - it can be seen and heard. The rims were checked when I had the tires put on (31 X 10.50)...