Jeep Enthusiast Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-19 of 67 Results
  1. TJ Wrangler Technical Forum
    Thanks for any recommendation. This soley is about $ for the time being. I have a 2001 TJ with a brand new clutch, recently my skid plate came off, and I have not been drivng it until it gets put back on. However I did notice that now my second gear will not engage (grinds) sometimes it stays...
  2. Wrangler Rubicon 392
    Just bought a 2022 Wrangler 392 XR and looking underneath that oil pan looks vulnerable especially for a Jeep that is 6000 lbs. I’m debating just a skid plate for the front area to protect the oil pan and tranny area versus the entire undercarriage area including a muffler plate. I’m concerned...
  3. WK Grand Cherokee & XK Commander Forum
    Hello All, Can anyone make recommendations to source Rock Rails or Sliders and an Engine Skid Plate? Rocky Road Outfitters seems to have some nice rock rails and sliders for the WK. Anyone have good or bad experience you can share about them? I'm having a very hard time finding a replacement...
  4. XJ Cherokee Technical Forum
    So I'm building a skid plate for my 94 XJ, I want it to protect the oil pan area, transmission pan, and transfer case area. This is my outline so far any thoughts or comments? The red circles are spots for bolts where the "metal" plates will connect, and the purple hard lines are where the final...
  5. TJ Wrangler Technical Forum
    Hello, I have a 2001 Wrangler TJ with serious frame corrosion. I’m not handy with major repairs so to there’s not much more I can do with it. The skid plate is holding on to the frame by only one side, meaning 3 bolts. So the transfer case is sagging a little. Of course I’m nuts driving it in...
  6. Vendor Display
    Rancho's Front Dana 44 and Dana 30 differential Glide Plate for the Jeep Wrangler JL mounts to the front axle casting, and allows for a much smoother glide over obstacles forward and backwards. The Glide Plate protects your differential casting from direct contact in severe offroad conditions...
  7. TJ Wrangler Technical Forum
    I noticed my skid had some light surface rust, so I jacked the car, undid 10 bolts and dropped the skid to do a quick sand and spray. In the meantime, my roommate needed a drive to school so I dropped the car, and drove it to and from the university (approximately 12 miles of highway driving). I...
  8. Misc. Jeep Parts
    Zip45066ModelWranglerKeywordsGenRight Gas TankStateOHCitySpringboroPrice850ShippingWill ShipPaymentPayPal ,Cash OnlyThis is the 15 Gallon GenRight Crawler™ COMP Gas Tank to fit a Jeep TJ / LJ (1997-2006). NEVER MOUNTED, STILL IN PLASTIC. Has a small scratch on the skid pan from shipping. It is...
  9. JK Wrangler Technical Forum
    I recently removed my rust covered fuel tank skid plate in my 2009 2 DR JK, I have rust proofed this jeep, 6 out of the 8 years I've owned it. I missed a couple years, but felt I was keeping on top of the rust for the most part. This vehcle spent 4 years in Toronto, 2 years in St. John's Nfld...
  10. Rancho Suspension
    Our latest glide plate is for the TJ/LJ rear Dana 44. Helps you glide over rocks and not get hung up. Check with your local retailers on pricing. :)
  11. TJ Wrangler Technical Forum
    Hi, I am pretty (very) new to this, so this may be the wrong place for this post. I have hit a wall as to what is causing my Jeep to leak. I had a mechanic replace the seal, and I am sorry to say I don't know where anything is at in regards to the transmission. I will say this, the transmission...
  12. TJ Wrangler Technical Forum
    Hey fellow Jeepers, So after a fantastic trip to Moab, doing only the most difficult trails, I quickly realized that the stock fuel tank skid is not going to cut it. It seems to be a step up from tin foil on the pre-2003's. I am trying not to add a bunch of weight to the vehicle to maintain...
  13. Skid Plate repair

    This is a different side view of my skid plate assembly.
  14. Skid plate repair

    This is a side view of the frame with the two spring steel plate on top and bottom. I have lowered the skid plate by one inch with through hardened unbolt washers.
  15. Jeep CJ Forum
    I have an 85 cj7 with a leaking fuel tank. When I dropped the tank I noticed the drain holes in the skid plate were plugged with rust scale. There is a plastic shield there that insulates the tank so it's not metal to metal. The problem is the plastic was cracked in 3 places and I can't bring...
  16. TJ Wrangler Technical Forum
    Like the title says, the bolts on the skid plate for my trans pan wont stay in. The two smaller ones that attach to the transfer case skid stay in but the larger bolts that go into the frame will not. With the drivers side bolt I can screw it in all the up until the last 1/8th inch or so of the...
  17. TJ Wrangler Technical Forum
    Hi I have a 1998 Wrangler and I noticed all the nuts on the back of the skid plate(Facing towards the bumper) were all missing and was hanging down. I tried to put temporary nuts on for the moment because I was away from home but then the actual bolts started turning. I thought they were held in...
  18. YJ Wrangler Technical Forum
    A few years back I moved to Virginia from Colorado and have not really had the opportunity to resurrect my latest Jeep project that I started before getting busy again... I decided to do some wheeling this weekend and within the first hour while backing up I had a dead tree lift up and slowly...
  19. TJ Wrangler Technical Forum
    Hello everyone, I have a 2006 Unlimited LJ, auto, 3" Zone, RE upper and lowers and 31s (until I can regear and get 33s). What I am looking to do now is replace the muffler with a thrush welded to give it a better sound. I know most of, if not all of the stock muffler is covered by the skid...
1-19 of 67 Results
Top