Search Results for ‘shifting problem’

Hello, My WK is a 3.7, laredo, 2006 Recently when I drive on occasion the transmission won't downshift. Ill be driving at ~45 mph but my tach reads close to 4k rpm. Usually I can shift into neutral and the load drops off the engine, bringing it back down to 1000 rpm. If i turn off and...

I bought a TJ this week and have driven about 200 miles on it. So far I have had 1 really rough shift in a parking lot pulling into a parking space and another 2 or three noticeable rough shifts while driving. That first rough shift moved me in the seat and was audible to the point where my wife...

Hello, brand new the the forum and somewhat new to working with jeeps. My automatic jeep started to act funny with its shifting. After awhile of bad-terrible shifting I noticed that when I would put it into Reverse or Drive the idle would take a dive and almost kill it, but would recover just...

So I'm wanting to go look at a wrangler that has clutch problems was hoping someone could help narrow the problem down before I bought it. 93 Wrangler, 4.0, ax15. The transmission was just replaced with a remanufactured transmission. The guy just replaced the clutch master and the slave...

2004 TJ Jeep Wrangler X, all stock, manual. yesterday while driving the "Clutch went out". The clutch is slighty harder to depress than leading up to this issue. It would not go into any gear. Only way to get it home, and it was a short distance when this happened, was to turn engine off, put in...

Good Morning I installed a used transmission last night in my 93 YJ 2.5L (the PO told me it shifted fine). It has the internal slave cylinder. When I went to shift on the test drive after finishing, I can't get it go into 1,3, or 5th gears. 2, 4, and R work great and shift fine. I installed...

Hi Everyone, I went to off-roading couple of days ago and on the trail I was putting it on 2nd shift. on the way back home I noticed it is not shifting to 3rd gear I stopped the car and turn on and off put on N but no result. I start driving it to find a gas station and call for tow truck and...

I have a automatic 2009 Jeep Wrangler Unlimited Rubicon. My Jeep has this weird problem were it feels like it is changing gears, but it jerks so hard that it feels as if it is pulling backwards. I have noticed it do this when it is changing gears and also when I am excellerating and it is not...

So my question is does anyone know what would cause my transmission to slip between 1 and 2 intermittently . I have a Automatic 4L 6 cylinder engine 4x4. I've only had the jeep for less than a week and already had to have it towed due to battery or starter issues. I took it back to the dealer...

My '95 Grand Cherokee is stuck in limp mode & won't shift past 2nd gear unless I rev it up to 4000 rpms & let off the gas. After shifting past 2nd, I have to feather the gas pedal to keep it from downshifting back to 2nd where it gets stuck. I have read I should check the TCM. Where is that...

My daughter has a 2001 Grand Cherokee and the transmission is being indecisive. It can't decide if it wants to stay in first or shift to second. Just as an experiment, I started shifting it manually to see if it was the transmission itself or some kind of sensor instead. Luckily, it shifts just...

I have a 98 GC with the 5.2V8 limited and 151K miles. I beleive the transmission is the 42re. I went out the other day and it would not shift out of 1st gear. I did manage to get it to do it a few times. If i would rev it up pretty high and take my foot off of the gas it shifted but only a few...

i recently swapped transmissions from my 95 Laredo from a 94 limited. the trans that is in the 95 works however, the trans has been sitting for a while at least 2 years and i did not do anything to it but put new fluid in. so here is the problem. start engine. put into drive or any other...

1990 YJ Swapped in a 4.0L from 1996 XJ. Converted the motor from AW4 setup to an AX15 setup. Installed new clutch disc, pressure plate, pilot bearing, clutch fork, throwout bearing and sealed master/slave setup during the swap. I have been working on several things during this swap so the...

Hey, I'm new here and need some help. Have the 96 ZJ grand with 4.0L I6 and 42RE. Had problems with shifting. in Drive its in 3rd all the time, can shift down to 2nd manually and shift back up manually but won't shift into 1st or OD. pulled code p0748 which was the Governor Pressure Solenoide...

Hi, I just bought a used 2006 Jeep Wrangler Rubicon Unlimited with the 6-speed NSG370 manual transmission. When I shift from 1 to 2 there is a grind or clunk as if the gears aren't synced. Double clutching helps and the problem goes away after driving for a while. Alternately I can avoid the...

Let me preface this by saying I don't really know if this is the type of forum to put problems like this in, but I figure it can't hurt to get an enthusiast second opinion. Also, I'm not that much of a car guy, so some of my terminology might be misused or off; take what I say at face value...

I sank the TJ into mud the other day on accident (I had been avoiding it all day) and started having tranny problems right away. I got it home, changed the fluid/filter and flushed it with fresh Valvoline ATF+4. The old stuff didn't look too bad, there was a bit of crud in the pan but really not...

I've got a 73 cj with the 3speed. Maybe T-14, not really sure. Its got some problems with shifting sometimes. 1. If I'm pulling pretty hard in high, and try to downshift into 2, it will not go at all. I slow down enough in the process of trying to get it into 2 that I can go into 1, but...