Jeep Enthusiast Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 128 Results
  1. Jeep BU Renegade & MP Compass Forum
    Hi! I am needing my Trunk Interior Quarter Panel removed to be replaced. How do I go about removing it? Any help, tips, tricks or additional information would be great. Thank you!
  2. Jeep Cherokee & Comanche Forums
    2017 Cherokee needs heater hoses replaced. There does not seem to be much information on how to remove the damaged hoses and Hubby is getting frustrated Can anyone offer any suggestions. Thanks!
  3. XJ Cherokee Technical Forum
    I have a 2000 XJ with about 140k on it. The rear leafs are flat when I have the usual load in it. Neither smile nor frown. The ride is fine on the road. BTW the shocks seem fine. When I step on front or rear bumper and jump off the bumper comes back to center. No bounce. What made me wonder...
  4. WJ Grand Cherokee Forum
    This is a simple post in case it helps anyone save some time in the future. My door panels had a couple of loose parts and I needed new clips in there. Looking around the internet it seems that there have been many colours of clips and it took me a good while to work out that the general...
  5. Engines & Drivetrain
    Need some rear diff help if possible: Ring gear in my dana 44 has lost some teeth, so now I know what's been making that horrendous noise. Bad news is I need to replace or rebuild...that is my question. Want to go as economically as possible as Jeep is advertised for sale. Bad timing to say...
  6. WK Grand Cherokee & XK Commander Forum
    Disregard, manufacture states the passenger side can use either model. Thanks, ----------- Hello Everyone, 3.7 Laredo 4X4 (4 Wheel All the Time) 2006 Grand Cherokee The boot tore and threw grease on my front passenger side CV axle. Has anyone purchased a new assembly for these? I can't...
  7. WK Grand Cherokee & XK Commander Forum
    I just bought an '06 WK. Overall it is in good shape, but I found that the front of my driver side rocker panel is severely rusted to the point that it 'was' barely holding the clip for the rocker guard. Are there any reasonable ways to replace the panel altogether? Any input would be great!
  8. YJ Wrangler Technical Forum
    Hi everyone! I'm in search of some answers regarding rear axles in the YJ's. I have a 88 YJ Base that I bought a while back. When I bought it the previous owner said that the owner before him replaced the rear axle with a higher ratio gear setup. I'm not sure what it is currently but I know the...
  9. WK Grand Cherokee & XK Commander Forum
    Hi all, I just replaced the front bearings on my 2005 wk. I had some help and got it done in about 4 hours or so. I figured I would at least share some info pictures and video on my project so others can ask if they have questions. I am not a mechanic, but I can at least give you my...
  10. YJ Wrangler Technical Forum
    Hello, i am replacing the seals around the bottoms of the windows on my jeep. Have been looking around for a tech on how exactly to do but have had no luck. Does anyone have advice on how to do this? :cheers2:
  11. JK Wrangler Technical Forum
    I have a 2009 2-door Wrangler X with vinyl seats that I absolutely hate. I picked up a pair of stock JK cloth seats(year unknown) to replace them. I do not believe my 2009 X has side airbags, but the current seats do have some sensors attached to the seat bottoms(see pictures). The first pic...
  12. ZJ Grand Cherokee Forum
    The handle that you would normally pull to release the hood has come off. My dad had some vise grips attached to the end of the cable that was sticking out, but that bit of cable has since broken off, and I need to replace it. I already have the new cable ready, but I'm not sure where to start...
  13. ZJ Grand Cherokee Forum
    Hi all, I was wondering what the best aftermarket shocks for a 1998 ZJ 4.0L would be. My shocks are pretty bad and I want to replace them, but don't know which to get. I heard that if you don't get a certain kind than they may be too rough or too soft. Any sort of insight would be useful!!
  14. JK Wrangler Technical Forum
    Hi, First time posting here. My dog chewed one of the rear side seat belts in my 2012 Sahara Unlimited and I was wondering if I could replace just the belt? If so, which OEM part number should I be looking for? Thanks, Frederick
  15. Engines & Drivetrain
    I'm getting code for torque convertor. For the past 9 months the tranny has acted really wierd, getting pregressivly worse. Main problem was shuddering. Sount like i was running over speed bumps when I went up steep hills or floored it in first. Anyways, as of last night it really has gotten...
  16. Jeep CJ Forum
    My CJ is burning a pile of oil. Its a toy. I dont (cant) put a pile of money into it so I am trying to decide whether I want to rebuild it myself (with outside machine work), or just find a used engine (258, 304, or 350), and replace the whole thing. Anyone have any experience with either? I...
  17. JK Wrangler Technical Forum
    ive been reading that its recommended to replace all the track bar and control arm bolts due to improper sizing from factory. if i buy new teraflex arms and track bars does it come with new hardware? if not, is this northridge kit a sufficient kit...
  18. XJ Cherokee Technical Forum
    I've done some research here on swapping out my heater core (getting fogged windows on interior with heat on real bad). When I remove the heater core, here are a few questions I have not been able to get answers to from other threads- 1- Passenger Airbag- Does the dash-mounted passenger airbag...
  19. YJ Wrangler Technical Forum
    Good morning! So... A couple of questions... Should I do an SYE on my 95 YJ with a NP231J OR just replace the bent output shaft? Here's what happened: one of the bolts which held the rear drive shaft U-joint to the rear differential sheared and the rear end of my rear drive shaft let loose...
  20. XJ Cherokee Technical Forum
    Yesterday I climbed into the 1988 Cherokee, turned the key, and all I got was CLICK. Tried some more with the same result. I figured the starter is shot - it's probably original. Today in anticipation of a trip to autozone for a new starter, I degreased and pressure-washed the old starter and...
1-20 of 128 Results
Top