Search Results for ‘relay’

Hi everyone, I was looking for information on wiring my LED pods into the circuits for my high beams while also maintaining the manual turn on switch I have. I know that the amperage draw from the relay should be negligible but I wanted to confirm that it shouldn't be enough to cause...

2001 Wrangler 4 cyl. I have found threads on the fan speed switch overheat problem but nothing recent. I would like to try the relay mod but the threads are so old the pictures are no longer there and I cannot seem to view the pics in the gallery. Does anyone have any new info on this issue? I...

I have a 1998 jeep Cherokee sport. so after a bad noreaster,no flooding.my pcm/fuel relay fuse keeps blowing under the hood. also my gauges don't work and interior lights/radio. so i disconnected battery and reconnected everything and then tried fuse again. it didn't blow.lasted 3 days now and...

My heated seats were not working so I pulled the covers and found the broken wires and soldered them back together. The passenger seat started heating but the driver seat was still cold. Switched the relays under the seats and the driver seat started working and the passenger seat went cold...

Hi everyone, I just recently joined the forum and was looking for some easy upgrades to start on my XJ and I found the relay harness upgrade for the headlights. I checked out the other relay harnesses I saw that lots of people recommended and they looked good, but some reviews complained of...

Here’s a quick way to test the electronic fan circuit to determine if the relay and fan are working. All you need is a jumper wire and can test both components at once. No need for a volt meter or bench testing either part off the car. To test only the relay, disconnect the fan connector (at...

Hi, I have a 2008 Grand Cherokee Overland with the 3.0 CRD engine. Recently when I start the vehicle there is a noise that sounds like metal on metal and when I turn the key to the off position the engine continues to run but it is runs very rough like it is only on 2 cylinders. When I then turn...

Anyone have issues with their S-Pod relays burning up rather quickly? I've had a couple relays go bad for my offroad lights. Seemingly out of nowhere. Not sure if it's the pod or just cheap relays.

I need a replacement pdc box (1991 Wrangler YJ 2.5 4 cyl) not just the lid... can't seem to find it aftermarket and local jeep dealer says Chrysler doesn't make them anymore... any ideas?

im having the same problem as a lot of people on here but i couldnt find any solutions that worked. i've replaced the fan switch and resistor and everything worked great for about a month and now the blower motor stopped working. i could smell some sort of burning before it went out. i replaced...

So I don't post here a lot, but wanted to say that this is a fantastic resource for Jeep owners, especially my wife's XJ. I have had a few problems I've tackled over the years, but one has come back to haunt me. I've never applied the cylinder 3 injector insulation, and we've occasionally had...

Hi all, Let me start out by saying that I have read more than 40 hours on every Jeep Dodge website I could find. I have talked to multiple certified mechanics. I have been troubleshooting for over 2 months, and I could sincerely use some help. 95 Jeep Grand Cherokee 5.2 Laredo Problem: When...

93 YJ Engine died and won't start. No Start and Code 42. The jeep has been driving fine, last night I cranked it up to leave Sonic, got half way around the parking lot/drive thru in 2nd gear feathering the gas and the engine just died. The starter engages, but it doesn't start up. OBD pulling...

i just replaced the flasher relay and when I hit a bump in the road, my blinkers stop working. It seems like the relay doesn't plug all the way in. If I give it a good squeeze they work again. I'm guessing that it shouldn't be free hanging and that it needs to be clipped somewhere but I can't...

I have a 99 XJ Cherokee with a non functioning horn. Does anyone have a wiring diagram that takes me from the steering wheel all the way to the horn? I've checked the fuse..Good I've changed the relay...Good I am able to jump the relay and make the horn honk while its jumped, so I know it...

Hey everyone, I am at a loss. I took the day off from work to get this fixed again. The other night I left my Jeep running as it was -2degree. I ran into my office to grab a few things and came back and my cab was completely filled with smoke. I tore the dash apart to make sure there was no...

I am rewiring 4 KC daylighter style(off brand) lights the PO had on my jeep. I followed the the diagram from the KC website but had to buy aftermarket wiring equipment. The lights work though I think I may have wired something incorrectly. I believe the problem may be the relays, I have 2 60amp...

Earlier I was driving my Jeep and my oil pressure was low and my gauge was on but once my engine warmed up, the pressure went back to normal. After shutting it down for an hour or so and driving home, I felt the RPMs start to drop even though i was giving it gas and then my engine randomly shut...

I live up in Alaska, and starting just a couple of weeks ago, my battery powered radiator fan wont turn off when the car is turned off. I was wondering if overheating was the problem, so I checked the coolant, and I found that it was a little low. I filled up the reserve and I thought that...

I am looking into assemblying weatherproof Bussmann relay/fuse boxes, as I know there has been a demand for them. I used one myself in my last YJ with great success, though it cost me a ton as the person who used to assemble them had stopped not too long before I decided to get one a few years...