Search Results for ‘rear’

Rear OEM drive shaft in good condition Will get pics and measurements this weekend If interested, PM me here

Hi all, So my cj needs new shocks, PO had a SOA lift but never ended up swapping driveshafts and such. Anyways, old shocks are too long for stock (I think) ride hight. My problem is the front shock mounting bolts measure 10.5" centre to centre and everywhere I'm seeing shocks for Cj7 the...

I have a 2005 jeep wrangle unlimited that has the 2-Piece Removable Hardtop like this one "2-Piece Removable Hardtop for Jeep Wrangler Unlimited LJ (2004-2006)" we replaced the shocks on the back window, with a couple heavy duty shocks. It turns out that they were to strong for the window and...

So i recently bought a '02 TJ that had the rear hardtop glass shattered previously. Its currently boarded up for the time being. So the hardtop on is an aftermarket Smittybilt top. I have had zero luck searching for replacement glass online and i'm pretty sure that the OEM glass wont fit an...

I have a 1997 jeep grand cherokee laredo 4x4 I want to lift it 4 inches but wanted to get some opinions on what rear to put in, tire size and if I should do anything with my trans. And if I need a new driveshaft. Any other things anyone can add I'm missing that would be much appreciated. Thank you.

I installed a 4in currie lift. w/ double adjustable upper control arms. Installed the rear track bar relocter bracket. and I cant get my stock rear track bar to fit. At first i realized my axle was to far foward. So i adjusted my lower control arm about 1.5in to move my axle back. Then adjusted...

Hey all, I'm trying to replace the latch/lock on the rear window of my hardtop. I took apart the rear trim (the plastic/fiberglass part on the inside and outside of the bottom of the rear window that the the gas-filled pistons attach to to lift the rear window up.) The bolts holding the latch...

I have a 1999 TJ with 2.5" Rough Country springs and 1.25" body lift on 33s. I took it off-roading for the first time last weekend and had a blast, however the bushings on my rear upper control arms blew out. I'm looking for advice on where to go from here. Also, I do NOT plan to upgrade to...

I've got a leak that I've been noticing more often over the past few weeks. From what I've researched it looks like it might be oil coming from the rear main seal, can anyone confirm this? It leaks about a drip every minute when I've just parked, but slows down pretty quickly when it cools...

I had a 3.5" lift put on recently and needed to lengthen the rear driveshaft because the splines were showing. After I lengthened it 1 3/4" the rear driveshaft won't fit back into the yoke. I'm trying to install with all tires on the ground. Is this driveshaft too long now? Should I try to...

Hello. For some reason, I cannot get my rear wiper working. The cables are plugged in and the hose is connected as well. The rear wiper used to work intermittently and the fluid would always work. However, at the same time the front wiper intermittent setting wouldn't work, but low and high...

Hey folks, I've had this problem for some time, but was never able to find any clues on what could be the issue. The rear wiper is intermittent by design, however, it is working abnormally. -The wiper will move about 1/5 of the way then stop. Eventually it will go all the way and come back...

Hey gang, For about a week and a half, I have been experiencing intense squeaking coming from the rear end, mostly when I go over bumps. I haven't changed anything back there, for quite some time, so I'm not sure if it's a question of bushings going bad, or what. In mid May I replaced the...

I just got a 1989 jeep cherokee Laredo 4x4 4.0L that I traded a shotgun and couple other things for. This is my first jeep, always wanted an XJ, anyways I'll get to the point, she's an ex-deer camp special that's been sitting up for over a year and has a lot of needs. First on my list is a rear...

ok im looking at a danna 44 from a willys jeep my question is it will it bolt right in my cj7 in place of the amc 20

hey all I cannot seem for the life of me find some damn rear outer wheel bearings not sure which ones are right on rock auto, seems like they have "axle bearings " listed and wheel/hub bearings ? are these the correct bearing and seal #s? NATIONAL Part # 5707 and NATIONAL Part # 8660S ? thanx...

Recently bought this YJ, I have the rear seat however I do not have any of the mounting brackets and/or the seat belts. I've been trying to track them down with absolutely no luck. From junkyards to quadratec I can't find anything. Anybody know of anywhere I could look or am I dedicated to...

Lately when I shift into reverse the "Service Park Assist" message on the EVIC pops up, it's then disabled, and red lights across the rear. just washed the XK and everything seems to be in order. The dealer says they don't see any codes. Any ideas? My only guess is that 1 (or more) sensors are...

I have to replace my rear shackles on my '00 xj to pass inspection. I'm looking at JKS 1" greaseable shackles. My concern is that since my leaf packs are so shot (worried face at best) and my rear end will sag more with the shackles ability to flex the pack more. Is my concern valid. And I do...

Hello, bought my jeep from my aunt 2ish years ago and have only really used it for driving around. I always noticed the brakes seemed a little weird, not that i've had issues stopping, but just not very powerful. (I wasn't a danger to others on the road) This winter I was in probably 6 inches...