Search Results for ‘position’

Just something I ran into here and I'm wondering if the Chiltons book is right related to timing. This is the order of the spark plugs etc on the cap. #2 being at the front. Distributor rotor at 3 o'clock when installed correctly. So, is this what yours looks like? Everyone says the rotor...

Hi all, Rebuilding a 2.5l and noticed that the 3rd cam bearing (from the front) has 2 oil holes but the bore only has one oil passage. At which position does the second oil hole go? I found one thread on the forum asking this very same question and the only answer given was that it shouldn't...

After replacing my crank position sensor 3 times, it still won't start. I had a bad wire in the connector and the sensor is now hard-wired. The signal wire gets 5vdc output even when I hand crank the engine. (All the way to the PCM). Do I need to look for a HZ signal in the 5vdc? I read where...

I'm doing the electric fan swap on my '90, 4.2 YJ. I got all my stuff from a Volvo (junk yard), except the fan switch (auto parts store) and switch housing (ebay). The thin shroud that I have for the fan places the center of the fan motor to the left of the water pump (facing the front of the...

I am hoping that someone can chime in providing input regarding moving the front axle forward ~1". What are the pros/cons of pushing your front axle forward 1"? Would I completely be screwing up my alignment, track bar location? At the moment I have adjustable control arms for the bottom...

I've been pondering this for a while and would like to get everyone's take on it. The desired end result is: 1) Double-shear frame mount 2) Works with lower (and hopefully any) lift heights 3) Doesn't contact the tierod or diff 4) Doesn't require use of DPA 5) Maintains correct geometry with...

Just going back together after a frame swap where, among other things, I had the transmission out and removed the shift lever from it. No further work other than cleaning and a "rattle can overhaul" to the transmission. With the skid plate installed, set the transmission over in the skid plate...

I have replaced my throttle position sensor twice on my 2002 Jeep Wrangler Sahara 4.0L, once with a value TPS and then again with an expensive one. The code keeps coming back and the jeep continues to run funny. Do I have a problem with my wiring? If so how do I trouble shoot it? The code is...