Jeep Enthusiast Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-11 of 11 Results
  1. ZJ Grand Cherokee Forum
    My 5.9 limited ZJ has the worn NP249 transfer case coupler problem causing wheel hop in parking lots when it warms up. Upon further inspection, I also noticed I had a ripped open CV boot, and the U joint in the front drive shaft was worn. I don't wheel with it, and I don't drive it in the...
  2. Engines & Drivetrain
    I have a 1995 Jeep Grand Cherokee with the 5.2 and the 249 transfer case. I'm in the process of swapping in a 242 case, but I want to make sure I get the right donor. The case is dated July 1994. Can anyone tell me based of the attached picture if this is the old or new style gear cut? I've read...
  3. ZJ Grand Cherokee Forum
    I'm in the middle of replacing the vc on my newly aquired 94 grand cherokee. I've got it all back together, minus the tail cover, but the rubber portion of the oil tube is too short by about 1/2 inch. This is the stock tube, and it was disconnected when I pulled it apart. I can get some longer...
  4. ZJ Grand Cherokee Forum
    My 95 ZJ has a minor leak coming from the rear output shaft of my NP249. I still have fluid in it, but my concern there is that I seem to have a knock coming from that area when the rpm begins to drop (backfiring?). I also happened to notice that this started around the same time my oil...
  5. ZJ Grand Cherokee Forum
    I have a 95 zj with a np249 Quadr-Trac system that is so far stock save for an exhaust. I'm looking at a Budget boost, (I have my eye on Rough Country's 1.5 budget boost) however on their site it says not for AWD. Is that the Quadra-Trac np249 that I have? Why wouldn't this kit work and can...
  6. ZJ Grand Cherokee Forum
    5.2/46RH/249TC Has anyone replaced their seal and experienced the SAME amount of leakage? I realize I'll get flamed for going Napa and not Mopar, but it was all I had access to at the time. I'm willing to order a new one and get under there AGAIN, but only if it's going to fix what's going on...
  7. ZJ Grand Cherokee Forum
    I've adjusted the linkage- it is not the linkage. Anyways, I haven't found a thread yet that will describe to me what is happening when a tc gear grinds and will not engage. I'm looking at the blown up diagram in the Haynes manual and still can't determine why 4lo works so well, yet 4hi does...
  8. ZJ Grand Cherokee Forum
    Hey guys, I have a 93 ZJ limited with the 249. I had it up on a lift the other day and noticed that in park, the front wheels are not locked together and will spin, unlike the rear wheels which are locked (it was in Park) but the front driveshaft does not spin when i spin the wheels. Is this how...
  9. Engines & Drivetrain
    I have a 97 Grand cherokee with the 249 quadtrac. I want to swap in the 242 selectrac but its from a 94 grand cherokee. Is this swap going to be possible? If it is am I gonna have to buy anything else?
  10. ZJ Grand Cherokee Forum
    Hi im new here I need some help you guys look like you know what your doing. I have a 1995 jeep grand cherokee laredo with a 5.2 v8 dana 30 front dana 35 rear and a np249 transfer case. It has 300,000 I think. Im not sure because it says it has 66k but the sticker says 290k and its been awhile...
  11. ZJ Grand Cherokee Forum
    I have a 96 ZJ with the NP249. When going straight at any speed, I can hear the transfer case make a noise and it gets higher in pitch with speed. You can be on the gas or coasting, doesn't change it. The only thing that makes it go away is if the trans is in Neutral or of I turn the steer...
1-11 of 11 Results
Top