Jeep Enthusiast Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 49 Results
  1. JK Wrangler Technical Forum
    Me needs help, on my 08 JK I had a code P1404 EGR close position, P0205 Fuel Injector, P0404 EGR “A” Control circuit range. I replaced the fuel injector using OEM from the dealer and ordered plugs,wires,EGR, and ignition coil from rock auto. After installing the fuel injector I was good no...
  2. WK2 Grand Cherokee Forum
    Anyone got any guide/tips or trick on the removal of the bank 2 catalytic converter?
  3. Jeep CJ Forum
    In case anyone is interested. Came across this today. Not mine and I do not know the seller. Looks like this is a rebuild kit for the 6 cyl manifold damper. Ad says more than 10 available...
  4. Jeep CJ Forum
    Hey Guys! I have a 1975 CJ5 and have been working on getting the jeep to run. It has ran beautifully before in the past but last year started having a few issues and would seize up like it wasn't getting enough air. This past few months I've replaced the solenoid, battery, coil, distributor...
  5. XJ Cherokee Technical Forum
    I have a set of Torque Tube headers to install on my 2000 XJ 4.0. Has anyone tried to mount a heat shield to the bottom of the intake manifold? I have some galvanized sheet metal... While I have the manifolds off, I'm thinking cut that to size, insulate with high temp cloth (or maybe just...
  6. JK Wrangler Technical Forum
    2009 X 2DR 3.8 Automatic I am rebuilding the engine after 185k miles because a mechanic friend has donated his time. I'll be doing timing chain, water pump, new cam, checking valves, pushrods, lifters, gaskets, new radiator, fuel tank skid plate, new wheels/tires, wrap, etc. Yesterday we took...
  7. TJ Wrangler Technical Forum
    I've been having some problems with a vacuum leak on my '02 recently(I shoved a sock in the intake and it kept running). i did a gasket swap a few weeks ago when i was tightening up the bolts that connect to my exhaust. I assume it was just a poor gasket or the manifold bolts didn't torque right...
  8. XJ Cherokee Technical Forum
    So my exhaust manifold is cracked, surprise, surprise... :| I've got a new one on order that'll be here in about three days. I've got the chilton manual and it really doesn't seem that difficult to fix but I'm no professional.. I was hoping someone could point me towards a good write up of a...
  9. Engines & Drivetrain
    Hello I recently purchased a 1985 Jeep CJ7 that had been modified with a 304 AMC motor - Question is there is a hose hooked to a vac port on the back of the motorcraft 2150 carb that was connected to a port at the back of the manifold. The hose had a pcv valve midtream. The engine ran rough and...
  10. TJ Wrangler Technical Forum
    I plan to replace my crack manifold in few days. I'm in my drive way and pretty good in mecanic but never done that type of job before. The bolt was there for 16 years. What do you suggest me to help prevent broking nuts in the head. I'm aplying lose nut from the last two days. 1- remove the...
  11. TJ Wrangler Technical Forum
    I plan to change my jeep manifold and have never done this job before. So I have a few interrogations. I have done a lot of mechanic in the past but not on exhaust manifold. -First I do not have a torque wrench, do I really need it to do that job or it's optional? I have the spec to tighten the...
  12. JK Wrangler Technical Forum
    Hey everybody, I have an '07 four door JK that recently had a check engine light. When I took it in to get it looked at the mechanic said I had a crack in the left exhaust manifold and my catalytic converters were going bad. I have my jeep registered in a state without emissions laws so I've...
  13. Jeep CJ Forum
    Hey all, figured that since I could not find this information anywhere else I am sure others are looking too... I live in Iowa and since we do not have any emissions crap to deal with I decided to remove the air injector system since it was in the way of where I wanted to install my OBA York...
  14. YJ Wrangler Technical Forum
    has anyone had their exhaust manifold not line up after replacing the gasket? can get all but one bolt back in(top 2nd from firewall wont line up). can see where the exhaust manifold covers part of the bolt hole. any ideas? thanks
  15. TJ Wrangler Technical Forum
    Need help deciding on a exhaust system from manifold back. I am not that well knowledge on exhaust systems. I was looking at JBA headers but don't seem to be able to find JBA parts for the rest of the system. does it matter if the exhaust system is mixed brands? if i had mixed brands is there...
  16. TJ Wrangler Technical Forum
    I am having 2 issues with my 2002 TJ. 135K miles and is my daily driver, so she's getting up there, and might need a few things replaced. 1. My oil pressure gauge after highway driving (only highway driving at this point, no issues around town), and coming to a stop, my oil pressure gauge...
  17. TJ Wrangler Technical Forum
    Hey there I've got a low output 2.5 intake manifold leak at the head. I have the replacement gasket n all ready to put on. While I'm at it I plan to replace the exhaust manifold because i understand they're prone to cracking n they're dirt cheap as far as exhaust manifolds go. Given the common...
  18. XJ Cherokee Technical Forum
    Ok, i know i probably screwed something up. I just finished replacing the exhaust manifold on my 99 Cherokee 4.0, which of course meant i had to remove the intake manifold, power steering pump and electric fan to do it. I put everything back together and now when i start the motor it...
  19. TJ Wrangler Technical Forum
    Hey guys a few weeks ago my exhaust got really loud and upon further inspection I found I had a cracked exhaust manifold. It is the two piece style so it is a little rarer than the one piece style but evidently it happens. Sa as a result I decided to be a little cheap (wait this become...
  20. TJ Wrangler Technical Forum
    I know that the 2.5L are known to have problems with cracked manifolds. I have already replaced the manifold once, which was about a month and half ago, and now I think it is cracked again or has a blown gasket. To tell you the whole story in a few sentences, I took the Jeep to Silver lake sand...
1-20 of 49 Results
Top