Jeep Enthusiast Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-19 of 59 Results
  1. Jeep Picture Requests
    I'm working on getting a plan for the steering connected on the Dana 44 I am putting under my jeep. I have a 4 inch lift, and am keeping the axles spring under the axle. Anyone have pictures of how they did this? I also have 3/4 ton hubs/breaks out of a 70s/80s K20/K2500 so that may complicate...
  2. Engines & Drivetrain
    The other day my drive shaft snapped off. So I replaced the yoke, and both U joints. After that it ran fine. Yesterday I was driving to work when it started acting up. When accelerating, I would push in the clutch to shift and it felt like the back of the jeep would sway right a little bit. It...
  3. YJ Wrangler Technical Forum
    Ihave 87 jeep yj with a new stock motor with 2150 motor craft carb and tf999 transmission. The problem is that when i accelerate hard the temp will get way hotter than usual and then the jeep loses power and won’t go above 40ish mph. When i get on a back road the temp will drop really fast and...
  4. Engines & Drivetrain
    Has anyone ever tried the reman throttle bodies from Autoline for 91-95 4.0l? they have part number 14795 on Rockauto for $86 and $50 core. I was going to replace the bearings in my factory throttle body because the shaft was loose and i’m chasing an annoying whistle that I think Is vacuum...
  5. YJ Wrangler Technical Forum
    I'm at that place where most YJ owners have been at some point. You guessed it, the 4wd isn't engaging. It could be the switch on the t case. It could be the actuator. It could be a failed vacuum hose. It could be time for either a cable kit or just a permanent vac delete kit. What are the...
  6. Jeep Wrangler Forums
    I have a 91 yj (2.5) with a 2000 xj motor in it. I've swapped all sensors and added the distributor. lengthened and added my extra injector wires. and a 95 xj ECM, I've checked pinouts but some are different names or do different things. I got it to crank over but it doesn't stop unless I turn...
  7. YJ Wrangler Technical Forum
    Long time listener, first time caller. I'll try to make this short. I have a 1995 2.5L 5 speed manual. Rebuilt the entire engine due to a blown piston skirt. Had about 215,000 on it. I also added a 2.5inch lift running 31x10.50. Started up and ran fine the other day after a 4 year sit while I...
  8. YJ Wrangler Technical Forum
    Hey everyone, first post here so take it easy on me! I’ve owned my 1994 YJ for about 2 years now, and I can’t get enough of it! Recently I’ve been having a problem with the vehicle shutting off while i’m driving, and just problems with the fire up in general. there are times where i turn on the...
  9. General Jeep & Off-Road Equipment
    The first time I needed my winch, I REALLY needed my winch. It was a place I go agate picking. A beach on a small point that extends out into the lake. At the edge of the beach is an immediate drop off, just past the water's edge. And the pea gravel that makes up the beach is pushed there by...
  10. Audio, CB/GMRS/Ham Radios, GPS, & Electrical
    I'm new to the forum so forgive me if this already exists. I am restoring a YJ to pass down to my son and I'm trying to make all of the options work as they did from factory. The new challenge is wiring my YJ's hardtop options that did not come stock on the jeep as the hardtop was purchased...
  11. Audio, CB/GMRS/Ham Radios, GPS, & Electrical
    New to the forum so correct me if I'm posting in the wrong neighborhood. Now to the problem. So I just picked up a 1993 YJ 2.5L 5 speed and drove it for a few days without issue. Then all of a sudden all my gauges stopped working at the same time. The lights all still worked(except my brake...
  12. General Jeep & Off-Road Equipment
    It rained pretty hard here for the past 2-3 days and after it, all got cleared I checked on my 94 YJ and come to find out that there's water all over the floor on both the driver and passenger side carpet, the inside of the doors were dry so I know I closed the door right, but where could it be...
  13. YJ Wrangler Technical Forum
    Hey. I have a !994 jeep yj and the windshield wipers have stopped working last week and i replaced the motor and it worked. The other night it was raining and they stopped working again. What could cause this to happen? I dont know if there is too much stress from the linkage that it burns...
  14. Engines & Drivetrain
    hey there new to the forum but no where new to jeeps but this jeep has me stumped i acquired this 1993 jeep yj 2.5cly fuel injected from a friend who said he couldn't get it started i had ruled out every thinng anyone cg down to the computer reading alll the forums i a big sign says it was the...
  15. General Jeep & Off-Road Equipment
    I’m hooking up my Badland Harbor freight 5k LB Winch and have a question about the control buttons and cords. (Yes I know it’s a crappy winch, but its all I could afford.) I’ve mounted it and I’m hooking it up to the battery and need to run the control lines. It came with two control buttons on...
  16. YJ Wrangler Technical Forum
    Recently we got a 1995 Jeep Wrangler YJ and the first week all was great until we left the lights on an ran down the battery. After jumping the battery it never seemed to want to stay charged so we just bought a new one knowing the 3 years the guy had the jeep before us he put less than 300...
  17. YJ Wrangler Technical Forum
    I am buying new seat risers for my 91 yj and I am wondering if anyone has tried the corbeau riser slider combo. The risers and seats in my jeep are from a tj so my new corbeau Moab seats don't fit so I figured I would upgrade to all new risers and sliders
  18. YJ Wrangler Technical Forum
    Here's the deal....I've got an 87 YJ with some motor problems. While trying to troubleshoot and get it fixed, I stumbled upon a 94 XJ that I can pick up for $900. I need to know if this will be compatible with my YJ. Here's the vehicle specs 1987 Jeep Wrangler 4X4: 4.2L I6 T999 Automatic...
  19. Engines & Drivetrain
    Hi Jeepforum. I have a 1995 Jeep YJ SOA, 33's, 5spd with 8.8 rear, NP231 w/ SYE. Recently when I have been doing light rock crawling I have been experiencing intermittent "Grinding" or "Scraping" metal noise whenever I hit a steep incline. The noise has only ever occurred when I am in 4Low...
1-19 of 59 Results
Top