Jeep Enthusiast Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 26 Results
  1. Jeep CJ Forum
    Help! Please! I am having a hell of a time getting my 1985 CJ-7 to start, or even turn over. I can get the engine to crank (won't start, though) if I swap the i and s connections on the solenoid, but it won't stop cranking when I turn the key back to off. Have to pull the wires to get it to...
  2. Jeep CJ Forum
    1984 CJ7 w/ stock steering column. Have got to the point where I have to turn the key almost 180 degrees to start. Looked at the ignition adjustment posts but didn't see this problem. I'm thinking I need to drop the column and adjust the switch position but I'm also worried I might just need...
  3. YJ Wrangler Technical Forum
    So, over the course of the last 2 days I pulled and disassembled my steering column all to change the ignition switch. (Long story, yes I now know you don't really need to pull the whole column to replace the switch on top of the column). Everything else went back in and back on. Only the switch...
  4. KJ Liberty Forum
    Hey all, I've an issue with my '02 Liberty Sport. There seems to be an issue between the ignition switch and the starter relay as the ignition switch doesn't fire the starter. However, the relay is fine. With the key in the ignition in the on position, the engine can be started by pushing the...
  5. KJ Liberty Forum
    Afternoon, first time poster. I am in a bind. I have a 07 Jeep Liberty 4WD 3.7l ( I believe) V6. I parked it on an incline (Engine facing Downhill) and let it sit there for a couple of hours [common Practice]. When I went to go start it would not turn over. After quite a few attempts (over 20) I...
  6. ZJ Grand Cherokee Forum
    Morning everyone, had a quick question about an odd electrical problem my 97 Grand Cherokee seems to be having. Also I posted a video link below which shows the problem I'm encountering. I apologize about the position of the camera at the time, I forgot to change orientation before uploading it...
  7. TJ Wrangler Technical Forum
    Hey guys my first post! Just lost my only key to my 1998 Jeep Wrangler Sahara this past weekend. In an idiot move I changed out the ignition cylinder instead of getting a new key. (Haven't gotten registration yet and locksmith wouldn't do it.) This was done by drilling a path for the cylinder...
  8. YJ Wrangler Technical Forum
    Here Goes Driving down the road and my 1988 jeep dies. Nothing at the ignition switch. Seemed like the battery was dead but lights were bright. I can bump the starter at the starter relay and it turns over perfectly. Found a burnt wire on the starter relay ( centre top ). Fixed the...
  9. YJ Wrangler Technical Forum
    Hey guys this problem has plagued me for much too long and it needs to be fixed. The problem is when I go to start her with the key i get nothing. I have to jump it at the starter with a screwdriver. Checked the ignition fuse it's good. Checked the battery with a multimeter its good. Fuel pump...
  10. Jeep CJ Forum
    I have a 84 CJ that has been sitting dead for awhile. Ive been trying to revive it but the ignition wont even turn over (yes it is connected to a fully charged battery). What is the problem? :confused: I would love to get this beautiful thing running again. :help:
  11. Audio, CB/GMRS/Ham Radios, GPS, & Electrical
    Hi. I have Grand Cherokee 2011 Hemi. Recently the car started giving me problems when starting, and the dealership cannot diagnose the problem. The car starts perfectly fine, and then after about 2-3 seconds the engine cuts off clean. This happens several times until eventually it stays...
  12. XJ Cherokee Technical Forum
    How do you check and set the timing on a 4.0 and how do you know what the timing should be?
  13. YJ Wrangler Technical Forum
    Alright I've got a small issue, I've changed the cap ,rotor, plugs, wires, fuel filter, cut the cat out, changed the coil, cleaned the injector, drained the fuel put fresh gas in, new oil and filter and air filter, heater core, and pvc valve. still cutting out. runs like a top until it gets to...
  14. Jeep CJ Forum
    Driving down the road the other day and heard a loud backfire and lost compression. Had it towed back to the house and finally started working on it today. Just bought this Jeep about a month ago so wasnt expecting much trouble because it was in solid condition. The engine turns over and has...
  15. TJ Wrangler Technical Forum
    Hi all, first post here. I'm not just new to jeeps but I'm also a car noob. Extent of my work usually doesn't go past being able to change my oil. (Although I'd like to learn to be become more tech-savvy.) Anyway, I just purchased a new battery ('01 Wrangler. Automatic 4L) thinking maybe my...
  16. YJ Wrangler Technical Forum
    I could use some help with my 89 YJ Wrangler 2.5L. When I turn the key to start I get a click from the solenoid, but starter doesn't turn over. When I turn the key to acc I get buzzers and guages and all, but once I turn over to engage the starter all the power to the whole jeep dies. (after...
  17. KJ Liberty Forum
    I want to be as detailed as possible to give any readers as much information as possible. Around 9 months ago my wife bought a used one owner 2002 Jeep Liberty Sport 3.7L V6. The Liberty had 136,000 miles on it when she bought it but the owner had oil change and maintenance records and the...
  18. ZJ Grand Cherokee Forum
    First off let me say thanks for all the help i have gotten over the years for my jeep. Symptoms: Unreliable starting. Sometimes it will start right up and others i can sit there and crank it all day and nothing will happen. Sometimes it does it when its hot (100+) sometimes when its cooler...
  19. TJ Wrangler Technical Forum
    Over the past 2-3 days I have been having a problem with starting. 97 TJ, 2.5, no mods. Get in, turn the key and no lights, no sounds, nothing. Today, trying to get to work I had the same experience so I left the key in the "ON" position and raised the hood, began visually inspecting around the...
  20. YJ Wrangler Technical Forum
    Hello all, I am new to this community and looking for some advice. It might be hard to get over a forum without seeing/hearing the vehicle, but I figured I'd try. My Jeep won't start. I have a '91 Wrangler, 6 cylinder 4.0 liter, that my family has owned from the factory. For the last couple...
1-20 of 26 Results
Top