Search Results for ‘front’

I have an 83 CJ7 Laredo and looking to buy a factory Chrome front bumper to replace the aftermarket that i have.

Hi all, So my cj needs new shocks, PO had a SOA lift but never ended up swapping driveshafts and such. Anyways, old shocks are too long for stock (I think) ride hight. My problem is the front shock mounting bolts measure 10.5" centre to centre and everywhere I'm seeing shocks for Cj7 the...

Hello everyone, first post here (I have a '93 Bronco that I have posted about on BroncoZone). My son has been playing bumper cars with my 2000 XJ. The last event involved a jumped curb that punched a 3" hole in the tire, damaged the aluminum rim and the lower swing arm mount on the right side...

My front driveshaft keeps failing and it is because of the 4 inch lift I have on it. Does anyone know any websites or shops that will have or build me a custom one for the lift that I have?

Hello, I removing the front propeller shaft out of my 05 WK. Because the cv joint in the rear is torn and clicking. I got the back 6 bolts out just fine. My problem is the front 4 bolts. I got 2 of them out but the last 2 are being tricky. One of them is half way out and wont go anymore and then...

Could use some help on how to troubleshoot a leak on a 2005 Jeep Liberty Limited with 4WD. Have a water leak Front Passenger Floor- wet carpet. It has happened four times. First time I hand washed the car and after my wife noticed the wet carpet. To me that didn't seem enough to cause anything...

Hey guys, a little side project I have been putting time on at work. Its about ready for production. What do you think?

I am hoping someone can help me. I am not new to CJs and have done a lot of re-wiring on them but I am stuck on this one. I have a 73 CJ5 that I am trying to restore. I was having problems with the headlights and front running/signal lights so I replaced them all along with new wiring for...

Hey guys, I'm new to this forum but I've been meaning to sign up for little while now as I traded in our subaru for an 07 WK and our mariner for an 09 wrangler in the past 4 months. Reason for my post, yesterday I got into a fender bender in a parking lot with my WK. I've got a $1000...

Started getting a grinding type noise coming from the front left I thought. Researched the forums and thought it was low/ old diff fluid. changed that still had the noise. just changed the front left axle shaft today but still getting the grind. Possibly not enough friction modifier?? axle shaft...

Im thinking about removing my stock front bumper because I like the look without it more. Is this going to be a bad idea? Or anything I need to worry about? And I will not be offroading while its off. If its a bad idea I wont do it, but Im wondering if its possible or if anyone else does it...

Yes, I already used the search function but I couldn't find anything less than 4 years old. Hoping maybe something has changed as far as prices go. The joints on my front drive shaft are completely shot and need to be replaced. Mopar said the part only comes as one piece for $625. The install I...

Lately my TJ has been pulling very hard to the left on the road. Accelerating, at all speeds, in neutral and slowing down. I've had the front aligned and the tires rotated and rebalanced. Today I measured the front again with a tape measure using the front and back of my inner sideways and they...

Lookng at the bumpstops on my front springs its pretty bad around it. I've looked around online to see what I need to replace but can't find anything confirming the part. A lot of the searches also refer to the rear spring perch instead of the front. Here is what it looks like looking in front...

So I've developed a squeaking/ squealing/ scraping in my front end. I disconnected my front ds and it had no effect on the noise. I jacked up one tire and tried to spin it and had a good deal of resistance. I was able to get the noise to happen faintly when I spun the tire as fast as I could...

We all know we can swap in front control arms in our ZJs but how about using front lower control arms from a WJ and installing them in the rear (replacing the ZJ's stock rear lower control arms) Is it possible? Is it safe? Would it be beneficial? Logically, I think it's possible since they are...

Hi all, Recently my TJ has developed a rattle at the front left (drivers side) engine bay and I've searched the forums but am stuck and need some help. :confused: While driving normally, there is no rattle at all and everything seems fine (although I may not hear it over the engine noise etc)...