Search Results for ‘flexplate’

I have a 1991 Jeep Cherokee, and it makes a ticking noise that seems to get louder when the car is warmer. At over 1000 rpm, the noise gets slightly faster and goes away. I looked at the flexplate, and it is wobbling. The outer part moves about .5-1cm. I tried tightening the bolts with a...

Can anyone help me with a Flexplate for an AMC 360? Item or part number. Possibly a Pioneer Part#?

So I've had the jeep about a month now, upgraded from a TJ, I know jeeps make noises but some don't sound right. I have a chhh, chhh, chhh, chhh, chhh type noise and sometimes a little clank coming from my oil pan/ tranny area. I can BARELY hear it from the top but when riding around with the...

hi guys, so i have a 97 Tj sport auto with about 152k on it give or take. i have a knocking noise coming from what sounds like the bellhousing or very back of the engine. it calms down when warmed up or when in neutral or park. though it is still audible at all times. for a while i thought it...

So I have searched every forum I can think of for days and still yet to find a solution. Bought jeep with bad flex plate(999)...replaced it, broke another within 30 miles.:mad: alignment is perfect, even put in new dowel pins, no crank walk, input shaft play. Dropped trans and found that it...

I'm in the process of swapping out a 4.0 for 4.0, and it's my 1st time. I got a "new" motor at the junkyard, and it's ready to go in. However, my Haynes manual says that I should index my flexplate to the torque converter with paint, so when I put it back together, I can line them up. One...

Hi All, Is the flex plate/ flywheel the same for the auto tranny as the manual? I'm swapping in a 304 that was hooked to a manual 3-speed to my '85 CJ7 that had a 258 and has an auto trans. Do I need to locate a flywheel from a 304/Auto trans, or will the torque converter bolt up to a 304 manual...

I have one that probably way 10 lbs then the other one about 50 lbs

I have a 1997 jeep cherokee 4.0 it has a loud rattle noise coming from the oil pan or right by the oil pan it sound just like as if the exhaust was rattling up aginst the drive shaft but its right by the oil pan . I have just replace the rod bearings because the shop I took it to told me it...