Search Results for ‘fender cutting guide’

I have a 2 inch lift on my 05 WK. I went ahead and bought 5 265/70/17 tires which are recommended by rough country for this lift. It says there is no modifications needed for these tires on a 2 inch lift. First day out in the mountains I ran into terrible fender rubbing to the point where the...

Before I start, this may become a build thread. after carefull consideration and a little proding i have decided to just do the work and enjoy my 78 Cherokee that was up on the sale forum. If you are looking you may know it but i will post more pictures because it helps all understand...

so i recently went to cut my wheel wells and did not look how to do it before so i just cut the rear ones at the top of the bend and it is above the pinch welds so now there is a large gap between the body and wheel well and i need to some how fill that vapor cover it in some way so water and...

Hey just got a great deal on some wild country mud terrains 30x9.5 but I still have stock suspension. She'll clear them heightwise but it looks like it will rub the front fender a bit. Whats the most minimal way I can trim to clear my turning radius? side note...I'm pretty new at all this so...

I originally planned on installing JCR Offroad Lower quarter panel armor along with their Stage 2 rear bumper I bought from them, but I wasn't at all happy with how bulky the corners were. So I decided to scrap the lower quarter armors and go with the much better cut and fold method and then...