I have a 2000 Grand Cherokee Laredo 4.7L V8 with approximately 148,000km. The oil is changed every three months (I never hit the 5,000km mark.) and the plugs were changed about 45,000km ago.
This past weekend while on a road trip, an odd ticking sound came from the engine when it downshifted...
Just got a 97 SE this past weekend. Been looking it over and getting familiar with it (changed out ignition switch, oil change and air filter change today). As I was adding new oil from the aforementioned oil change I found this unconnected wire:
Any help figuring this one out? I appreciate it!
I am in dire need of help resolving my engine issues. Please give your input. I am new to rebuilding, but have had a lot of success until my current problem. Please share your wisdom.
CJ-3B with a Dauntless 225 V6 Conversion, purchased in Nov 2009, clean title for $700, put into it...
Ok i am the owner of a 97 tj. it has a 2.5l 4 banger in it and it only gets like 14 miles a gallon. so i thought if im going to get bad gas mileage i should have the power to go with it. i want to find the best candidate. i would prefer something kind of unique. but still have off road abilites...
Ok, I posted this in my build thread as well but,
If you haven't seen my build Im doing a frame off resto to my 84 CJ7. I'm putting a SBC 327 in it as well.I need some help finding a decent rebuild kit with cam and lifters included. I found one from Engine Tech but until I found it I have...
Have had this problem since purchase, but is getting worse. (95 grand cherokee)Used to just stall after backing up and put into drive. Only engine, not battery or electrical system. Now at stop lights and signs, if not kept moving it tends to turn itself off. Could the transmission be doing...
I have a 1989 YJ and I want a to put a new engine in it. It currently has a 2.5L 4 cylinder engine.
What size engine can I go up to and still use the stock transmission it has in it now?
Price is the most important factor when buying said new engine, does anyone have suggestions as to when to...
I am new to this forum and I have a 1977 CJ7 that needs the head, intake manifold, exhaust manifold and the 2100 2bbl car put on. Anybody have a good shop or a good mechanic to take it to on the Atlanta area? I just want the thing to run its in good condition otherwise.
OK so few weeks ago I blew my 2nd 4cyl, i decided i was done w/4 bangers so i shopped around and found a 6cyl/5spd trans/t-case/computer/harness for $900 i went and picked it up and started pulling the 4cyl, i don't have pics of me pulling the trans or case but here is some pics of me pulling...
Trim Packages and Special Editions
Axle Gear Ratios
Wheels (Part 1)
Wheels (Part 2)
This information was gathered from several sources and is believed to be accurate for U.S. spec TJ Wranglers. If you notice any errors or have...
I have a 98 TJ (finally just paid it off) and I have tried getting it to display the error codes, but can't seem to have any success. I have switched the key on 3 times, 5 times, 4 times and several other tries but nothing happens. i'm I doing something wrong or can the codes only be retreived...