Jeep Enthusiast Forums banner
driveshaft

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 105 Results
Advanced
  1. JK Wrangler Technical Forum
    I have a 2012 JKU Rubicon with a 3.5" AEV Dualsport lift with geometry correction brackets. My front driveshaft finally blew out the seals so I ordered a 1350 front from Tom Woods. I have yet to install it. In the meantime, the rear driveshaft started making a click when letting off the...
  2. JK Wrangler Technical Forum
    I have a 2015 JKUR with the Mopar Stage 3 lift kit and have been trying to improve my steering. After installing new ball joints, tie rod and drag link I got an alignment and found my caster was only 3.2 degrees. My lift kit doesn't have adjustable control arms, so I was considering replacing my...
  3. WK Grand Cherokee & XK Commander Forum
    Hey everyone , I have a 2007 Jeep Grand Cherokee 4x4. Recently I have this clunky metallic sound coming from under driver seat. This sound only occurs when i accelerate hard from a stop.It feels like it is trying to catch transmission teeth or something . The reason i say that because while the...
  4. ZJ Grand Cherokee Forum
    I just got done with a lot of work, I have a '95 zj, 4.0, AX15 with a NP242 lifted 4" and 31" tires. I just got done - replacing the LP-D30 with a HP-D30, re-gear to 4.10, replaced the front driveshaft with a Tom Woods dual double cardan shaft (to correct caster) installed lunchbox lockers. and...
  5. Engines & Drivetrain
    I have recently replaced the T150 in my 78 CJ7 with a T18, with a 4" lift and will now need a rear driveshaft that will be shorter. I am dropping the transfer case down with shims between the skid and frame as it would have been from the factory. With the standard stock driveshaft I had no...
  6. Engines & Drivetrain
    Hello, My 04 WJ has been making a small clicking noise in the front end for awhile, sounds like the driverside. I have replaced the drive CV axle hoping this would be the solution, unfortunately it was not. I went ahead and replaced my pinion bearing on the driveshaft and still did not solve. I...
  7. TJ Wrangler Technical Forum
    I have what i call a dull metallic clicking noise coming from the driveline. Its increases in rate the faster the speed, its more noticeable under acceleration. It does it in 2wd, 4hi, and 4 low. I started off by inspecting all u-joints for play. Didn't find anything. I jacked the front and...
  8. RWK Haus Supply
    And on the 5th day... Call, PM, Text or email for these great promotions for the 12 days of Christmas. Robert 714-875-2414 [email protected] www.RWKHausSupply.com
  9. Vendor Display
    Jeep JK Yukon Driveshafts - Free Shipping and $75 off! Till Christmas, Get the highest quality and direct fitment Yukon Driveshafts with Free Shipping and use coupon code 'Christmas' for an Additional $75 off! Go here to see these quality driveshafts: Jeep JK Driveshafts
  10. RWK Haus Supply
    Jeep JK Yukon Driveshafts - Free Shipping and $75 off! Till Christmas, Get the highest quality and direct fitment Yukon Driveshafts with Free Shipping and use coupon code 'Christmas' for an Additional $75 off! Go here to see these quality driveshafts: Jeep JK Driveshafts
  11. WJ Grand Cherokee Forum
    Hey there, I'm trying to figure out what u joints I need and which ones need the ball joint kit. I tried searching with no luck. My jeep is a 2003 grand cherokee overland with a double cardon in the front and 2 u joints in the rear. I have the 247 transfer case, dana 30 front and dana 44a rear...
  12. Jeep CJ Forum
    Hi all, I purchased my first jeep last summer, a 1983 Jeep CJ7 Laredo, and am now having problems. It is my daily driver, so I'm quite gentle on it, no hard shifting, and no drag racing :laugh:. I sheared the bolts that hold the drive shaft at the rear differential in a sharp ditch...
  13. XJ Cherokee Technical Forum
    So I had the typical sparrow sound that people say is from the u joints. It was just an awful sound every time i accelerated. I decided to remove the front drive shaft hoping that it'll stop. Well it went from a constant loud squealing to an intermittent squeaking thats much quieter. Will that...
  14. Wrangler General Discussion
    I just wanted to write a quick note and express my gratitude to Tom Woods driveshafts for the excellent customer service I received while they addressed a minor issue I had with one of their driveshafts. Without question they immediately sent me a ups shipping label and promptly went above and...
  15. JK Wrangler Technical Forum
    Hi guys, I'm new to the forum and recently purchased a 2013 jeep jku sport. I am looking to install the Rough Country 3.25" progressive lift kit (shocks, coils etc) to accommodate 33-35" tires. I am interested if anyone had any issues with the angle of he driveshaft, exhaust clearance or any...
  16. WK Grand Cherokee & XK Commander Forum
    My front driveshaft keeps failing and it is because of the 4 inch lift I have on it. Does anyone know any websites or shops that will have or build me a custom one for the lift that I have?
  17. TJ Wrangler Technical Forum
    I have recently installed a D44 in place of the D35 that came factory with my 2001 Jeep TJ, in which I had an issue with the length of the Rear Driveshaft being too long to fit and allow for the correct "slip". I have uninstalled the Rear Drive shaft and are currently using my TJ as a front...
  18. TJ Wrangler Technical Forum
    I purchased a neglected 98 TJ that came with a Dana 44, 4.56s ARBs and NP241. I have done extensive work to make it driveable but am still having trouble with a vibration with the front drive shaft and am coming to you all for some help. Just to note since buying the jeep I have not had the...
  19. ZJ Grand Cherokee Forum
    I had a 3.5" lift put on recently and needed to lengthen the rear driveshaft because the splines were showing. After I lengthened it 1 3/4" the rear driveshaft won't fit back into the yoke. I'm trying to install with all tires on the ground. Is this driveshaft too long now? Should I try to...
  20. YJ Wrangler Technical Forum
    I'm having a bit of an issue guys, my leafs are sagging something bad. To the point where I cant put the rear driveshaft in. I called a guy today and he offered to sell me a set of 4 inch lift leafs for 200 bucks. Only problem is that is the majority of my remaining funds. The alternative is to...
1-20 of 105 Results
Top