Search Results for ‘driveline’

Hi, I have a problem with a hard noise*(like knocking) when coasting with my 2008 CRD Jeep GC (Quadra Drive II). I suspect it to be the front differential (as it is where the noise comes). It doesn't make that noise always. It just happens randomly when coasting. I changed the front...

Hey everyone, I'm trying to track down an issue that I ran into over the weekend. I was taking my 5.7 with QD2 up a light slope (cars going up and down it too) that was washboarded quite a bit. I hit one of the larger bumps and then began hearing a thunk that sounded like a bad U Joint or CV...

I have what i call a dull metallic clicking noise coming from the driveline. Its increases in rate the faster the speed, its more noticeable under acceleration. It does it in 2wd, 4hi, and 4 low. I started off by inspecting all u-joints for play. Didn't find anything. I jacked the front and...

Been a long time stalker of this forum and have really benefitted from this knowledge base! now i have a problem of my own driving me nuts. So my 94 YJ has had this terrible ticking sound for a while now. it seems to be directly related to wheel speed. It doesn't matter if the clutch is in or...

So I've been searching forums for weeks and coming up with different answers. The jeep is a stock 2004 LJ, so stock d44 in the rear. Randomly when I'm traveling very slow from a stop sign but mainly when I'm backing into the driveway down a hill, my jeep has a bad popping, clanking, binding type...

Alright guys a bit over a year ago my YJ took a beating. U-joint failed and ripped the tcase and driveline apart when going 60mph. I haven't had the money all year to fix it until I sold a truck. So this poses a question, in my area(75 mile radius) there are only a few YJs are being parted out...

Hey guys, Finally got around to putting a Zone 4 inch lift onto my TJ and some 33s. Got all the extras that come with the kit, a dropped pitman arm and used the transfer case drop for now. Couldn't be happier with how it handles and feels on the road. However, I have noticed that upon...

hey guys, i just ran across a Front CV Driveshaft. i didnt know that this was a thing and ive never heard of anyone having one. i would assume that its for 4wd with no vibes but even with a three inch lift i never got front vibes. i was wondering at what point this would be a good idea and when...

My jeep recently started to vibrate really bad when it hits 60mph. It started doing this after I took off the rear driveline to inspect some stuff, did I possibly put it back on wrong? is it the u joints? Or is it something else?

I'm having some issues with my 3:73 Dana35 rear axle in my 1999 TJ. Let's see what JF thinks about it... I recently removed a 2" BB lift, and replaced it with a 4" LA kit, with a high clearance skid plate, Tom Woods drive shaft, and SYE. The maiden voyage was yesterday (to work and back, about...

My '95 Jeep Cherokees front driveline rattles when driving down the road. The U joints seem tight. Thinking maybe its the yoke but any ideas?

Hello! I am putting a 4.5" Rough Country lift, 35" BFG All terrains, and an advance adpaters SYE kit on my '96 XJ. The one thing I had a question about is if I should use a front XJ driveline for the rear or if there was any other, better, but cost efficient driveline to use. I am only looking...

i have a 97 jeep tj with 2.5L 4 cylinder. 130k miles. only mods to engine are banks torque tube header and short ram intake. 3" coil spacers on the rear, and apparently 4.11 ratio on both axels. which i was told by aamco is not the stock option. but any way i was driving on the highway and my...

99 Jeep Grand Cherokee Limited 8 cyl. 4.7 quadra trac. Ok lots of noise and took it to two places. One said either transfter case chain MAYBE but for sure my front drive shaft had a ripped boot....so they said fix both but never heard the noise so would not guarantee. Took it to another place...

Sorry guys. I'm sure there is a thread somewhere similar, but bear with me. I took my jeep into a shop today to have my SYE installed. A little background. I have a 94 Jeep Grand Cherokee with the 5.2L motor, 249 Transfer case. I had a 231 that I pulled out of another Grand at the junkyard. I'm...

So Im a little confused and stumped. I have my stock d35 with a Aussie locker in and a 249 transfer case. when around town driving it seems normal i can feel the locker working and unlocking around tight turns. while out wheeling a couple weeks ago it just didn't perform like i had expected it...

i have a 94 ZJ but have been driving with no front drive shaft. today i almost got stuck (for the second time) not having 4WD, so now i am looking for a front drive shaft. i have the weird setup that has 4Lo, 4part-time, and 4full-time. my mom's boyfriend says the drive shaft i need is the 241...

I haven't had my CJ7 long before a clutch problem. When pulling the transmission, I found 1" tall spacers (hard plastic structured cylinders... not rubber) located between the stock transmission mount and the transmission itself. The skid plate is factory and is not dropped. The Jeep has a 4"...

Bought a '98 ZJ with 112K highway miles. Swapped a 3" lift from my '93 to the '98. The first "relatively tame" 4 wheeling I did blew out the front driveling. I discovered the forward end is a CV style and the back is a U-joint style. "Fortunatly" I had difficulty getting someone to rebuild or...

This is in regards to my '01 XJ, 140,000 miles. I installed a 2 inch lift last week. New springs, new shocks, along with new ball joints, tie rod ends, drag link, sway bar disconnects and track bar. Following the lift, I had the Cherokee aligned. I now have a vibration. It starts at about...