Jeep Enthusiast Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Jeep Engineering - Q&A Archive
    I just really relaced my rzappa on my 18’ Rubicon. my issue is I have torqued everything down and back in place and my snap ring is on the work bench not on the spline shaft it is the Tera flex replacement. Will I have to purchase a new kit or is it possible to get the cover plate off without...
  2. WK Grand Cherokee & XK Commander Forum
    Hey y’all, I believe I’m having an issue. I have a 2010 Grand Cherokee. Was changing out the passenger side strut when the wheel hub assembly leaned forward causing the cv axle to unattached itself from the stub(intermediate) shaft. Didn’t notice any damage to the cv axle, but went ahead and...
  3. Wrangler General Discussion
    I just wanted to write a quick note and express my gratitude to Tom Woods driveshafts for the excellent customer service I received while they addressed a minor issue I had with one of their driveshafts. Without question they immediately sent me a ups shipping label and promptly went above and...
  4. Jeep CJ Forum
    Hi guys, new to the forum and have a driveshaft question. I am in the process of finishing up the drive line on my new project, a CJ5. I have a 6" suspension lift asking with an axle over conversion. I swapped out the stock axles for a 44 front and an offset 60 that came off of a J4000. So the...
  5. YJ Wrangler Technical Forum
    OK I am in the midst of deciding whether or not to pull the plug on a SYE and Drive shaft. The problem is all I have right now is a rolling chassis with a new 2" BDS Lift and 1/2" Boom Shackles and no real weight on the Chassis to get an accurate measurement of Drive shaft Length which all mfg's...
1-5 of 5 Results
Top