Search Results for ‘crank position sensor’

2005 Jeep TJ X 4.0 My Jeep is my daily driver and last week when I went to leave work my Jeep would not start. We were able to narrow the problem down in the parking garage to the fuel pump. Had to loosen the fuel rail as the 05 does not have a schrader valve. We were able to get the jeep to...

Hi, This is my first time being on a forum, so any and all advice is highly appreciated and welcomed. I own a 1995 Jeep Grand Cherokee 4.0L What happened - Died while driving on my girlfriend on Oct. 31st. What ive diagnosed - its not getting spark, nor am i getting any diagnostic codes. what...

This is just a heads up. The crank position sensor on my 2013 JKUR was not covered under the 7-year drivetrain warranty. Here's a quote from the email I received from FCA about my out of pocket expense. "...the crank position sensor is an electrical component as it does not run through the...

I have a 1988 Jeep Cherokee XJ Laredo and I have been struggling with this cutting off issue a lot lately. Whenever I start it it cranks right up, but after I drive it or even move it a little bit, it starts to sputter and it completely shuts off on me. It starts right back up afterwords though...

I've a '96 ZJ with a 5.2. The transmission is out for overhaul and I note the crank position sensor gasket/grommet is wildly mangled ( I thought it felt weird when I replaced the CPS). I'd like to close that hole up. Does anyone know a source for that bit of rubber? The last two evenings of...

After struggling with a P1391 code for weeks I thought I'd post what I learned since I've seen no comprehensive method for troubleshooting this issue. Just to setup my situation, I had just completed a 4.0L engine rebuild and swap in my 2000 4.0L XJ. It started and ran, but would continually...

Alright guys, I've read my engine codes as 3,5,2,5,1,5,5. I would take it either as 35, 25, 1, (55 end code) or as 3(start) 52. 52, (55 end code). This is just after my latest clunk out with what seems to be a bad cps. Link to thread: http://www.jeepforum.com/forum/f11/cut-out-corners-3249969/...

Have a 85 cj7 with a 93 4.0 fuel injected motor. Just put a new ax15 trany in it and now it runs like poop. Wondering if it has to do with that sensor that is mounted on the top of the trany bell housing

I recently purchased a 2000 XJ that has a new engine, transmission (rebuild) and transfer case, all with approximately 1000 km on it. The body looked in good shape and it ran famously no rust underneath at all. Last week we took it on a road trip, "as little pavement as possible" through the...

So, I've put up with the 2.5l in my 94 YJ for a few years now. Last summer I threw on 35" BFG's and it's lacking in power. Here is my parts list (keeper and donors) 94 YJ : 2.5l Engine, AX5 Transmission, 231J Transfer Case 87 YJ (had a 4.2): BA 10/5 transmission, AMC 231 Transfer Case 94 XJ ...

98 Grand Cherokee with 180+K miles lost a cylinder...frankly ran pretty good on five, but being perfectionist who likes compression on all six, decided to try guaranteed reman 4.0, because it made the most $ sense if I wanted to keep the car. The Jeep was in all ways a Keeper. Along with the...

Morning everyone - I seem to be in a jeep fixing mode lately. My jeep seems to like to just shut off at random times. Be driving down the road, coming up to a stop light and it's like someone just turned the key off. No shudder or anything just shut off. I have been reading on this interwebs...

I have a 98 TJ 2.5L 5 speed that will not run doesn't even fire. Before it would fire up and run until warm then lose all power till it stalls out completely. I have changed the cam sensor and tried 3 crank sensor as well as the PCM throttle position sensor MAP sensor as well as many other parts...

I have a Lego jeep. It's a 03 ruby frame with a 05 ruby body and a 01 Sahara 4.0 engine. I was in the store and it was running out side. I got back in and headed down the road and I noticed the check engine like was on. (But not flashing) I was headed strait to the house to plug my OBD II and it...

Hey guys, new member here. I have been wrenching on my newly acquired 1997 TJ 4.0 manual for some time now as I had quite a bit to fix. I have however, run into an issue I would really appreciate some help with. As of yesterday, I have a no start issue on the Jeep. It cranks over very healthy...

My 95 Grand Cherokee is losing spark when hot.. The engine starts and runs great when cool. I can drive it for about 25-30 miles before it cuts out. I usually have to wait about 45 minutes to an hour before it will start again. Also noticed it is much better on the highway. I think it is the...

Edited: Sorry, just realized this is Cherokee thread. Not sure how to remove.. My 95 Grand Cherokee is losing spark when hot.. The engine starts and runs great when cool. I can drive it for about 25-30 miles before it cuts out. I usually have to wait about 45 minutes to an hour before it will...

Okay, I know there are about 1000 posts out here detailing stalling issues in older Cherokee's. I've read about 100 of them, and here's what I've done so far, need to find out what's next? 1. Car died on the freeway couple of weeks ago. Crank sensor was going south, didnt know at the time...

Last week it just shut off. Once while idling, started right back up, day before yesterday did the same thing 3 times. Yesterday, it failed to start, it cranked fine, I tried a few different things to try and get it started and it finely started , but I think I just got lucky. On the way home It...

so heres what happened. i replaced my clutch master cylinder and while taking it for a test drive it just died. after pushing it to the side of the road i tried to start it, it cranked but wouldnt turn over. i figured it was either the fuel filter or pump but the fuel pump was still working and...