Search Results for ‘check engine’

A few days ago my wk prompted me to "close fuel cap". It eventually was replaced by the check engine light. OBD reader shows p0456 (small leak). I replaced the fuel cap (old one was indeed not as tight compared to the new one) but the check engine light still persists after I drove two minutes...

**Update: Got a message back from the guy saying it's an 02 sensor and is being fixed tomorrow. Looking to pick up a (relatively) inexpensive Wrangler after not having one for roughly 20 years. I'm really trying very hard to keep myself between $6-8k which I know will be tough. That said, I...

Hello all, I recently changed some gaskets and when I put everything back together the engine had a rough idle and when in drive it wouldn't accelerate. I had 3 different error codes. P0123 P02111 (forgot the last). The issue was the TPS (throttle position sensor) was slightly unplugged. A...

About a month ago I got a check engine light for an EGR valve(P0404) and then I replaced it, and it got better. The light went off, acceleration was smoother and gas mileage was better. Today it came back on. Any ideas? Maybe the new valve went wrong?

Hello I have a 1993 Jeep Grand Cherokee Laredo V6 that has some problems. I don't know what to do because I've never had a problem like this before. So I have the Haynes Repair Manual. So long story short, someone tried to steal my Jeep and now I have to use a screwdriver to start it because I...

First history of the Jeep: 2001 with 165000 miles Has overheating history: New cooling system with the exception of the radiator. Current Status before Check Engine: The coolant would heat up in stop and go traffic, but the electric fan would keep the jeep from overheating. (thinking a new...

Hi Everyone, I was hoping someone could give me some help. I have a 2002 Jeep Wrangler. A few days ago my check engine light came on and the code read P1035. I did some research and read that it was an issue with an 02 sensor (bank 1, sensor 1). I replaced the 02 sensor and reset the computer...

Greetings everyone! I've been meaning to register for a while now, so here we go. Picked up a 96 ZJ a month or so ago and so far so good besides a busted brake line. About 160,000 miles. V8 5.2L, automoatic. First Jeep so go easy on me! So here's my issue... About a week or two ago I was...

I have a 2005 Grand Cherokee.. Problem #1 last Thursday about to head home from work I started up my jeep and I got a message saying "Service Elec Brake System" and a traction control light. All stayed on the whole way home. Has not showed up again. Problem #2 today I was about to head home from...

New to the forum (hi) I just bought a manual '88 YJ with a TJ roll cage on it. Unfortunately the instrument panel is missing the overlay that tells me which indicators are which (check engine, high beams, etc.). Does anyone have any info on what these slots indicate? hey are the squares...

On my 93 YJ, I've been having some problems. First, its not starting right up, gotta pump the gas. Look like a doof in the parking lot as everyone notices that my vehicle didn't start right away. After that the Check Engine light comes on, as i burn off a quarter tank of gas driving 7...

So last summer my check engine light came on and I knew what was and I had it scanned to be sure and sure enough it was sensor 2, replaced it and a few weeks later engine light came back on, ok so had it scanned again and came back to sensor 1 and replaced that one to. Well, few months later I...

The other day, I saw my check engine light was on. I checked it out, and my car spit the P1698 code out at me. I know it's something with the wiring under the dash, but what all should I try to do to troubleshoot/fix the issue? :confused:

Hello, I recently upgraded from a '97 TJ to a '06 LJ 4.0. The LJ has been sitting in the snow for a couple years so there's several leaks to address, but for $4500 on dana 44s with an e-locker rear, high pinion front spooled with coilovers, two sets of 35s, and a hardtop, there was no way I...

Hello All, I have a 99 Jeep Cherokee Sport 4.0L 4x4 with 185k miles. The Jeep is running well however I tried to get it inspected and it did not pass because the check engine light (CEL) was on with the P0505 code (IAC [Idle Air Control] system). The inspection person told me that my CEL was...

I'm not sure if i read this properly but i posted a video

I have a 2002 4cyl Jeep Wrangler Sport with about 108XXX miles. Yesterday my check engine light went on right as I started my jeep. It drove fine all day yesterday and mostly today (probably a total of 2-3 driving hours) and out of no where it started bucking in 3rd gear as I was approaching...

Today at a stoplight as I was sitting there in my 1997 Grand Cherokee ZJ the Check Engine light came on, and I looked at all of the gauges and everything seemed normal, oil was at 40psi or so; later on, I noticed that during idle the oil pressure would drop to about 30psi and then go up to...

I need help with reading the check engine codes in my '86 Cherokee with the V6 engine. The check engine light is always on. I am trying to use the instructions from this page. ...http://go.jeep-xj.info/HowtoECUcodes.htm... which says in part - "On 1984 to 1986 V6 only models the codes can...

Hi, I need some help please. My engine has a lot of miles but still running. I WANT to rebuilt or get a new engine what is better? what are my options? how much money do i need in total? is 3000 enough to get some thing with power and better miles per gallon. PLEASE HELP