Jeep Enthusiast Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-9 of 9 Results
  1. YJ Wrangler Technical Forum
    I am looking for the AC Compressor mount for a 1990 YJ with the 4.2 and manual transmission. I went to replace the alternator and snapped off the bolt that attaches the compressor to the belt tensioner. I have attached photos via .pdf file. Let me know what you think. The AC is above the...
  2. Jeep CJ Forum
    Hi all, I purchased my first jeep last summer, a 1983 Jeep CJ7 Laredo, and am now having problems. It is my daily driver, so I'm quite gentle on it, no hard shifting, and no drag racing :laugh:. I sheared the bolts that hold the drive shaft at the rear differential in a sharp ditch...
  3. Jeep CJ Forum
    After breaking off a bolt from my skid plate in my frame I searched all the threads and tried all the recommendations. Heat, lots of it and lots of penetrating oil and PB Blaster. Then welding a nut, but this wasn't perfect as the bolt is underneath and so I'm welding unsuccessfully upside down...
  4. WK Grand Cherokee & XK Commander Forum
    So I was finishing up my RC BB install, working on the last tire(of course) in the rear when the bolt holding in the bump stop broke clean off. Its flush with the threads holding it in. I don't have any power tools but could rent something and it looks like I'll have to do just that. Any...
  5. TJ Wrangler Technical Forum
    Hi I have a 1998 Wrangler and I noticed all the nuts on the back of the skid plate(Facing towards the bumper) were all missing and was hanging down. I tried to put temporary nuts on for the moment because I was away from home but then the actual bolts started turning. I thought they were held in...
  6. XJ Cherokee Technical Forum
    When changing my brakes the other day, I found that one of my caliper bolts had broken in a very unfortunate place. It's broken entirely within the caliper bracket (pardon if I use some bad terminology here, not very mechanically literate yet). So far I've 1: Drilled it through, though not...
  7. ZJ Grand Cherokee Forum
    Well, i had a few stripped lug nuts and tried to remove them. Tried the special sockets that remove stripped bolts, tried heatin them up, even heard two break loose a bit. But maybe four of them snapped off i guess because the bolts are hollow for some reason lol so we were gonna take a droll...
  8. XJ Cherokee Technical Forum
    Hey guys I have a 96 xj 4.0 that has a busted passenger side motor mount. The three bolts are sheared off and still in the block. My brother and I are going to fix it but only have a few hours to do it this weekend. We have a garage full of tools and a cherry picker to help lift the engine...
  9. Cheap Tricks & Fixes
    Have a 97 Cherokee and I was taking out the passenger seat today to fix something that was broken, and all three of the bolts the holy it down broke. I tried drilling out the bolts but the steel is to hard. Does anyone have any ideas on how to get these bolts out?
1-9 of 9 Results
Top