Search Results for ‘bell housing’

I wanted to ask if anyone could give me the distance from the front of the bell housing (right where it bolts onto the engine) to the studs on the trans mount that drop into the crossmember holes on an AW4. I don't have one to measure and I can't seem to find this online for this trans. Thanks!

Hey guys, I've dealt with this problem for a while. no change in performance, its more of a knock than a tap but, it goes away after the engine heats up and it is not an accessory (definitely rear of engine). I replaced the lifters, not that, def not piston slap from a broken piston skirt, it...

I have a 77 cj5 I took the t150 and bell housing out of it and installed a 74 bell housing and b&g t15. Ever since I have done this I have had clutch rod adjustment issues can I use the 77 bell housing on the 74 trans?? There was a difference in length between the two bell housings and I'm...

Hey guys. I need some help. I am a novice mechanic. My 89 4.2 Wrangler had been leaving a puddle of oil each time I drove it. Through the help of the posts on this forum, I was able to walk my way through changing out the rear main seal. It has helped enormously. I still have a few drops coming...

I have a '94 AX-15 which used an external slave cylinder, but I no longer have the matching bell housing. But I do have '91 AX-15 bell housing that is for an internal slave cylinder. Can I make the two work? Basically I would use an internal slave cylinder on an AX-15 that was expecting to...

I've got an 87 6 cyl, YJ. My clutch hydraulic system was giving me problems so I changed the master cylinder and it did not resolve despite there not being a leak from it or the line down to the bell housing. The slave cylinder was next to change so I bought a new one from Autozone to replace...

Ok, so a few months ago I started having an issue with a knock in my bell housing. It would only occur after I had driven around for a while, and seemed to correlate to the amount of RPM's. This noise would also only happen while in drive. Not reverse, neutral, or park. Took it to a shop to look...

Guys I heard the stories about the top two stud looking bolts that have to come out of the transmission to unhook from the engine. It took me less then 20 mins and this my 1st time ever removing any engine at all. Here is what I used my impact wrench a 3inch extention a 1/2 to 3/8 redue socket...

91 YJ got all bolts loose on the bellhousing to my manual trans and pushed away from engine about an inch or so.....wont go any further. anything bad happen if i crank on it?

Hey all again. Here's another dumb question. I searched the forum but either no one is as dumb as I am or I'm searching for the wrong keywords. I changed out my valve cover gasket and while I was look towards the rear of the engine I noticed a hole. It looks to be a manufactured hole where the...

So I took my 2001 Wrangler project jeep out for the first time over the weekend. Ran great until I drove it about 4 miles then I started getting a tin sounding grinding noise. It only happens when it gets hot, and seems to be coming from the bell housing dust shield. All I have done down there...

Howdy, MY jeep has recently started making a rather particular noise in the last 100 miles. The noise seems like its coming from under the transmission hump. Take in mind i had my transmission rebuilt and installed it myself. The noise seems to start around 25mph and only gets worse has my...