Jeep Enthusiast Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 45 Results
  1. ZJ Grand Cherokee Forum
    So the time has arrived, i just purchased an AX-15 and I’m going to swap it onto my 95 zj. Im making this post in hopes to get any information that could aid me in the swap, when I’m done I’m going to make a separate post going over the process as much as i can so i can help aid others if they...
  2. Engines & Drivetrain
    Hi, I'm rebuilding an AX-15 and am stuck at loose fitting c-clips. I have a B mark and need one .008" thicker. It looks like there are 5 different ones that came in several thicknesses and are no longer being produced. What are you guys doing for these c-clips? Is there anyone selling used or...
  3. ZJ Grand Cherokee Forum
    Hi i just finished up a 75% done Ax-15 swap on a lifted 96 GC and for the life of me i cannot find where to wire the reverse switch on the side of the transmission. If there is any wiring from the Tcm i can tap into for a switch in the interior i will take that too. I'll take wiring diagrams...
  4. Jeep Wrangler Forums
    I am rebuilding an AX-15 for a friend and when I took the transmission apart, the part in the photo was sitting in the bottom of the transmission case. I can't find anything on the parts diagrams that match this, so I'm at a loss for where it goes. Prior to fully disassembling the...
  5. YJ Wrangler Technical Forum
    Does anybody know what the circled part is called, or better yet, where to buy one. My '91 Jeep Wrangler with an AX-15 was missing this piece, and the previous owner had just filled the hole with silicon. I'm looking for the correct part to buy, but I can't figure out the right search words.
  6. TJ Wrangler Technical Forum
    Just bought my first TJ cheap off of a buddy. It needs some work but is just for riding around on the weekends. He told me it has been making some noise in the rear-end for about a month and that CarMax said it probably just needed rear diff serviced. He just put a new clutch in it about 2 weeks...
  7. ZJ Grand Cherokee Forum
    I just finished putting a AX15 in my '95 removing the 42RE. I figured just grounding the NSS so it will start, but then I discovered cruise will not work because the computer sees the NSS is in neutral while driving. Easiest solution I would think would be putting a switch on it for starting...
  8. YJ Wrangler Technical Forum
    Hey guys I decided to check on my transmission and possibly do a fluid change. However I noticed a gasket or something that once resembled rubber in the shift tower. It was all cracked and broken apart and only accounted for about 1/3 around the hole. However some of the gasket/rubber fell into...
  9. YJ Wrangler Technical Forum
    So I'm at the point where if I try anymore I may end up rounding the drain plug on my ax-15. Any help or suggestions? Also the previous owner never told me if the oil in it was synthetic or conventional. Is there anyway to tell the difference on old oil?
  10. YJ Wrangler Technical Forum
    JF- I hope y'all might be able to help me out or at least give me some ideas. To keep things concise, I do ask that y'all read the whole post before jumping to conclusions; based on other things I've read online while trying to troubleshoot this. Here are the symptoms: -Firewall very hot, 150+...
  11. YJ Wrangler Technical Forum
    Alright guys a bit over a year ago my YJ took a beating. U-joint failed and ripped the tcase and driveline apart when going 60mph. I haven't had the money all year to fix it until I sold a truck. So this poses a question, in my area(75 mile radius) there are only a few YJs are being parted out...
  12. YJ Wrangler Technical Forum
    Hi y'all, I have 94 yj Sahara, and the transmission has had syncros out since I bought the jeep 3 years ago. Well its finally time to get around to fixing it. I went to my local trusty jeep mechanic, and had them look at the master cylinder for the clutch while they were doing the retourque on...
  13. TJ Wrangler Technical Forum
    I found a 94 Cherokee AX-15 that I'd like to rebuild and use in a 99 Wrangler AX-15. I'm hoping it simply bolts in and I'm done.
  14. TJ Wrangler Technical Forum
    I found a 1994 AX-15 Transmission on CL for a decent price, and he confirmed that it had the external slave cylinder. Will this fit my 98 TJ? My current transmission has a couple bad syncros for sure, and now I have a driveline vibration that may also be inside of there. Any modifications...
  15. ZJ Grand Cherokee Forum
    5-speed ZJ Build Hi all, '94 ZJ Laredo Its stock configuration was as follows: D30 low pinion, D35 3.55 gears open diff, np231, 4.0l and a factory installed AX-15 I have done the following: ARB Bull Bar / Winch type New Class 1 jasper 4.0, Borla header, Hi flow cat, small turbo muffler...
  16. ZJ Grand Cherokee Forum
    Hi all, I have a somewhat rare 1994 ZJ Laredo I am making a bit of a project out of... Its stock configuration was as follows: D30 low pinion, D35 3.55 gears open diff, np231, 4.0l and a factory installed AX-15! I have done the following: ARB Bull Bar/winch type New Class 1 jasper 4.0...
  17. TJ Wrangler Technical Forum
    This kit has 2 Derale transmission coolers, PSC did not specify any way to tie into the transmission, no instructions or anything. Does anyone know how to tie in a cooler to the AX15 transmission? Looked all over the web and cant find anything on how to do this.
  18. XJ/MJ Cherokee Non-Technical Forum
    I have been thinking about swapping my '99 XJ from an AW-4 to an AX-15. I have thought about this for about a year now, and I still want to do it as bad as I did on day one, so I think this is what I truly want to do with my Jeep. I found a guy locally today who has owned 32 different...
  19. TJ Wrangler Technical Forum
    Now I know a lot of people have had issues with getting the 2 external Torx bolts on top of the engine, and I have already taken the engine out and am in the process of putting another engine in. I seemed to have lost the bolts that are around the rest of the bell housing that connects the bell...
  20. Engines & Drivetrain
    I have a '94 AX-15 which used an external slave cylinder, but I no longer have the matching bell housing. But I do have '91 AX-15 bell housing that is for an internal slave cylinder. Can I make the two work? Basically I would use an internal slave cylinder on an AX-15 that was expecting to...
1-20 of 45 Results
Top